Related Experiment Video
Updated: Jan 22, 2026

Using Phylogenetic Analysis to Investigate Eukaryotic Gene Origin
Published on: August 14, 2018
Structural variation and phylogenetic analysis of the mating-type locus in the genus Morchella
Hongmei Chai1, Weimin Chen1, Xiaolei Zhang1
1a Institute of Biotechnology and Germplasm Resources, Yunnan Academy of Agricultural Sciences , Kunming , 650223 Yunnan , China.
Abstract:
True morels (Morchella spp.) are a group of edible fungi that are in high demand worldwide. However, this group of fungi remains poorly understood in terms of its genetic structure, life cycle, and mating system. In the present study, we cloned the MAT locus in Morchella sp. Mes-20 using long-range polymerase chain reaction (PCR) amplification. Our results showed that the MAT1-2 idiomorph in the single-ascospore isolate YAASMCB-3 was 7.5 kb in length, harboring a single MAT1-2-1 gene, whereas the MAT1-1 idiomorph in the isolate YAASMCB-15 was 7.8 kb, carrying both MAT1-1-1 and MAT1-1-10 genes. Mating-type diagnostic assays of single-ascospore populations confirmed that Mes-20 is heterothallic. In addition, 42 collections belonging to 17 morel species (7 black morel species [Elata clade], 9 yellow morel species [Esculenta clade], and 1 species from the Rufobrunnea clade) were used to clone and characterize the MAT1-1-1 and MAT1-2-1 genes for development of the mating gene genealogies. In concordance with the multilocus phylogenetic trees, collections for the respective species were readily distinguished by well-supported lineages in mating gene genealogies. The topologies were consistent within the Elata clade, whereas the branching order and sister-group relationships slightly varied within the Esculenta clade. Our results show that species in the genus Morchella could be delimited by mating gene genealogies.
Related Concept Videos
Phylogenetic Trees
What is Variation?
The range, standard deviation, standard error, and variance are the different measures of variation.
Range: The range is the difference between its maximum and...
Types of Non-structural Cracks in Concrete
Plastic shrinkage cracks typically form within hours after the concrete is poured. The concrete's surface dries faster than the bottom, creating tensile stress that the still-plastic concrete cannot withstand, leading to diagonal or randomly patterned cracks on the concrete surface.
Locus of Control
Conservative Site-specific Recombination and Phase Variation
The recognition sites for Cre recombinase called LoxP...
Variation
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...

