Tracking the uptake of outcomes of hepatitis B virus testing using laboratory data in Victoria, 2011-16: a

Caroline van Gemert1, Wayne Dimech2, Mark Stoove3

  • 1Burnet Institute, 85 Commercial Road, Melbourne, Vic. 3004, Australia; and Department of Epidemiology and Preventative Medicine, Monash University, Alfred Hospital, Commercial Road, Melbourne, Vic. 3004, Australia; and Corresponding author.

Sexual Health
|July 2, 2019
PubMed

Related Concept Videos

Testing a Claim about Mean: Known Population SD01:11

Testing a Claim about Mean: Known Population SD

A complete procedure of testing the hypothesis about a population mean is explained here.
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
3.2K
Analysis of Population Pharmacokinetic Data01:12

Analysis of Population Pharmacokinetic Data

Analysis of population pharmacokinetic data involves studying the behavior of drugs within diverse populations to understand their pharmacokinetic parameters. Traditional pharmacokinetic methods typically involve collecting samples from a few individuals and estimating these parameters. While these methods are commonly used, they have limitations in capturing the variability in drug response among individuals or heterogeneous populations. Population pharmacokinetics is employed to address these...
690
Testing a Claim about Population Proportion01:24

Testing a Claim about Population Proportion

A complete procedure for testing a claim about a population proportion is provided here.
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
3.9K
Testing a Claim about Mean: Unknown Population SD01:21

Testing a Claim about Mean: Unknown Population SD

A complete procedure of testing a hypothesis about a population mean when the population standard deviation is unknown is explained here.
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used;...
5.6K
Conservation of Small Populations02:04

Conservation of Small Populations

Small population sizes put a species at extreme risk of extinction due to a lack of variation, and a consequent decrease in adaptability. This weakens the chances of survival under pressures such as climate change, competition from other species, or new diseases. Large populations are more likely to survive pressures such as these, as such populations are more likely to harbor individuals that have genetic variants that are adaptive under new stresses. Small populations are much less...
16.7K
Cattell's 16 Personality Factors01:24

Cattell's 16 Personality Factors

Raymond Cattell's trait theory offers a structured framework for understanding personality by distinguishing between two critical traits: surface and source traits. Surface traits are observable patterns of behavior, such as indecisiveness, anxiety, and irrational fears. These traits are less stable, varying across situations and over time. This means that they are less helpful in understanding the deeper aspects of an individual's personality.
In contrast, source traits are the...
2.4K