Combining P301L and S320F tau variants produces a novel accelerated model of tauopathy

Emily J Koller1,2, Elsa Gonzalez De La Cruz2, Timothy Machula2

  • 1Department of Neuroscience, University of Florida, Gainesville, FL, USA.

Related Concept Videos

Histone Variants at the Centromere02:30

Histone Variants at the Centromere

Histone variants are the histone proteins with structural and sequence variations. These variants may be regarded as “mutant” forms that replace their canonical histone counterparts in the nucleosomes. Specific post-translational modifications on the histone variants enable further chromatin complexity and regulate tissue-specific gene expression. The most common histone variants are from histone H2A, H2B, and linker histone H1 families. However, several variants of histone H3...
5.0K
Kendall's Tau Test01:16

Kendall's Tau Test

Kendall's tau test, also known as the Kendall rank coefficient test, is a nonparametric method for assessing association between two variables. This test is particularly useful for identifying significant correlations when the distributions of the sample and population are unknown. Developed in 1938 by the British statistician Sir Maurice George Kendall, the tau coefficient (denoted as τ) serves as a rank correlation coefficient, with values ranging from -1 to +1.
A τ value of +1 indicates...
1.1K
Accelerators01:17

Accelerators

Accelerators in concrete serve as admixtures to speed up the hardening process, enabling the concrete to achieve early strength faster. Although accelerators do not necessarily impact the time it takes concrete to set, they reduce this time in practice. A common accelerator is calcium chloride, which is particularly useful for hastening early strength development in cold weather or for rapid repair jobs that require quick heat generation after mixing.
The effectiveness of calcium chloride can...
278
Accelerating Fluids01:17

Accelerating Fluids

When a fluid is in constant acceleration, the pressure and buoyant force equations are modified. Suppose a beaker is placed in an elevator accelerating upward with a constant acceleration, a. In the beaker, assume there is a thin cylinder of height h with an infinitesimal cross-sectional area, ΔS.
The motion of the liquid within this infinitesimal cylinder is considered to obtain the pressure difference. Three vertical forces act on this liquid:
2.3K
Instantaneous Acceleration01:16

Instantaneous Acceleration

Acceleration is in the direction of the change in velocity, but it is not always in the direction of motion. When an object slows down, its acceleration is opposite to the direction of its motion. Although commonly referred to as deceleration, this causes confusion in our analysis as deceleration is not a vector, and does not point to a specific direction with respect to a coordinate system. Therefore, the term deceleration is not used. For example, when a subway train slows down, it...
22.7K
Acceleration Vectors01:30

Acceleration Vectors

In everyday conversation, accelerating means speeding up. Acceleration is a vector in the same direction as the change in velocity, Δv, therefore the greater the acceleration, the greater the change in velocity over a given time. Since velocity is a vector, it can change in magnitude, direction, or both. Thus acceleration is a change in speed or direction, or both. For example, if a runner traveling at 10 km/h due east slows to a stop, reverses direction, and continues their run at 10 km/h...
21.7K