Single-Cell Detection and Photostimulation on a Microfluidic Chip Aided with Gold Nanorods

Yujie Zhu1, Hui Xu1, Xunbin Wei2,3

  • 1Department of Dermatology, Shanghai Ninth People's Hospital, School of Medicine, Shanghai Jiao Tong University, Shanghai, China.

Related Concept Videos

Chromatin Immunoprecipitation- ChIP02:36

Chromatin Immunoprecipitation- ChIP

Chromatin immunoprecipitation, or ChIP, is an antibody-based technique used to identify sites on DNA that bind to transcription factors of interest or histone proteins. It also helps determine the type of histone modifications such as acetylation, phosphorylation, or methylation.
Types of ChIP
ChIP can be divided into two types - X-ChIP and N-ChIP. X-ChIP involves in vivo cross-linking of histones and regulatory proteins to DNA, fragmenting the DNA by sonication, and isolating the protein-DNA...
12.2K
Cancers Originate from Somatic Mutations in a Single Cell02:21

Cancers Originate from Somatic Mutations in a Single Cell

Cancer arises from mutations in the critical genes that allow healthy cells to escape cell cycle regulation and acquire the ability to proliferate indefinitely. Though originating from a single mutation event in one of the originator cells, cancer progresses when the mutant cell lines continue to gain more and more mutations, and finally, become malignant. For example, chronic myelogenous leukemia (CML) develops initially as a non-lethal increase in white blood cells, which progressively...
14.6K
Load along a Single Axis01:29

Load along a Single Axis

In structural engineering, the analysis of beams subjected to varying loads is a critical aspect of understanding the behavior and performance of these structural elements. A common scenario involves a beam subjected to a combination of different load distributions.
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...
632
Single Pipe Systems01:24

Single Pipe Systems

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...
439
Detection of Gross Error: The Q Test01:00

Detection of Gross Error: The Q Test

When one or more data points appear far from the rest of the data, there is a need to determine whether they are outliers and whether they should be eliminated from the data set to ensure an accurate representation of the measured value. In many cases, outliers arise from gross errors (or human errors) and do not accurately reflect the underlying phenomenon. In some cases, however, these apparent outliers reflect true phenomenological differences. In these cases, we can use statistical methods...
6.9K
Detection of Black Holes01:10

Detection of Black Holes

Although black holes were theoretically postulated in the 1920s, they remained outside the domain of observational astronomy until the 1970s.
Their closest cousins are neutron stars, which are composed almost entirely of neutrons packed against each other, making them extremely dense. A neutron star has the same mass as the Sun but its diameter is only a few kilometers. Therefore, the escape velocity from their surface is close to the speed of light.
Not until the 1960s, when the first neutron...
2.5K