Computational design of improved standardized chemotherapy protocols for grade II oligodendrogliomas

Víctor M Pérez-García1, Luis E Ayala-Hernández2, Juan Belmonte-Beitia1

  • 1Department of Mathematics, Mathematical Oncology Laboratory (MOLAB), Universidad de Castilla-La Mancha, Avda. Camilo José Cela, 3, 13071 Ciudad Real, Spain.

Related Concept Videos

Design Example: Traverse Angle Computations01:25

Design Example: Traverse Angle Computations

Traverse angle computations are a critical component of surveying, used to compute the internal angles within a closed traverse. A traverse consists of a series of connected lines forming a closed loop, often used for land boundary delineation or mapping. Calculating the internal angles ensures accuracy in the traverse geometry and is essential for checking survey data integrity.The process begins with known azimuths and bearings of the traverse sides. Internal angles at each vertex are...
315
Graded Potential01:19

Graded Potential

Graded potentials are localized fluctuations in the cell membrane's electrical charge, commonly found in the dendrites of neurons. The magnitude of these potential changes depends on the strength of the initiating stimulus. In a membrane at its resting potential, a graded potential signifies a voltage shift either above -70 mV or below -70 mV.
Graded potentials fall into two categories: depolarizing and hyperpolarizing. Depolarizing graded potentials typically occur when sodium (Na+) or...
6.9K
Types of Aggregate Grading01:15

Types of Aggregate Grading

Aggregate grading is crucial in economically obtaining a concrete mix with adequate strength, reasonable workability, and minimal segregation. There are four types of aggregate gradation: well-graded, uniformly (or one-sized) graded, gap-graded, and open-graded.
Well-graded aggregates include a complete range of necessary size fractions that fit together to create a dense matrix with minimal voids, represented by a smooth, continuous gradation curve. This type of grading ensures good...
1.4K
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
10.3K
Chemotherapy-Induced Nausea and Vomiting: Cannabinoids01:21

Chemotherapy-Induced Nausea and Vomiting: Cannabinoids

Tetrahydrocannabinol (THC) is a phytocannabinoid that primarily interacts with the CB1 receptor, a type of G protein-coupled receptor (GPCR) predominantly in and around the chemoreceptor trigger zone (CTZ) and emetic center. THC also blocks the serotonin receptor activity in the dorsal vagal complex (DVC) by inhibiting serotonin release. THC exerts its anti-emetic effects through these interactions, which are beneficial for patients undergoing chemotherapy.
Two synthetic agonists of THC,...
707
Sieve Analysis and Grading Curves01:19

Sieve Analysis and Grading Curves

Sieve analysis is a method used to determine the particle size distribution of aggregate materials. This process involves the following steps:
933