Related Experiment Video

Updated: Jan 22, 2026

Dermoscopy Aids in the Diagnosis of Discoid Lupus Erythematosus
05:39

Dermoscopy Aids in the Diagnosis of Discoid Lupus Erythematosus

Published on: May 16, 2025

582

An Overlapping Case of IgG4-Related Disease and Systemic Lupus Erythematosus

Srikanth Naramala1, Sharmi Biswas2, Sreedhar Adapa3

  • 11 Adventist Medical Center Hanford, Hanford, CA, USA.

Journal of Investigative Medicine High Impact Case Reports
|July 20, 2019
PubMed

More Related Videos

The bm12 Inducible Model of Systemic Lupus Erythematosus SLE in C57BL/6 Mice12:04

The bm12 Inducible Model of Systemic Lupus Erythematosus SLE in C57BL/6 Mice

Published on: November 1, 2015

18.6K
Skin Biopsy for Diagnosing Discoid Lupus Erythematosus05:44

Skin Biopsy for Diagnosing Discoid Lupus Erythematosus

Published on: June 10, 2025

902

Related Concept Videos

¹H NMR: Interpreting Distorted and Overlapping Signals01:02

¹H NMR: Interpreting Distorted and Overlapping Signals

Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
1.5K
Second Order systems II01:18

Second Order systems II

In an underdamped second-order system, where the damping ratio ζ is between 0 and 1, a unit-step input results in a transfer function that, when transformed using the inverse Laplace method, reveals the output response. The output exhibits a damped sinusoidal oscillation, and the difference between the input and output is termed the error signal. This error signal also demonstrates damped oscillatory behavior. Eventually, as the system reaches a steady state, the error diminishes to zero.
390
First Order Systems01:21

First Order Systems

First-order systems, such as RC circuits, are foundational in understanding dynamic systems due to their straightforward input-output relationship. Analyzing their responses to different input functions under zero initial conditions reveals significant insights into system behavior.
When a first-order system is subjected to a unit-step input, its response is characterized by its transfer function. By applying the Laplace transform of the unit-step input to the transfer function, expanding the...
403
Second Order systems I01:20

Second Order systems I

A servo system exemplifies a second-order system, featuring a proportional controller and load elements that ensure the output position aligns with the input position. The relationship between these components is described by a second-order differential equation. Applying the Laplace transform under zero initial conditions yields the transfer function, showing how inputs are converted to outputs in the system.
By reinterpreting the system, one can derive the closed-loop transfer function, which...
575
Classification of Systems-I01:26

Classification of Systems-I

Linearity is a system property characterized by a direct input-output relationship, combining homogeneity and additivity.
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
554
Classification of Systems-II01:31

Classification of Systems-II

Continuous-time systems have continuous input and output signals, with time measured continuously. These systems are generally defined by differential or algebraic equations. For instance, in an RC circuit, the relationship between input and output voltage is expressed through a differential equation derived from Ohm's law and the capacitor relation,
460
Keywords:
IgG4-related diseaseSLElupussystemic lupus erythematosus