A proposal for the structure of high- and low-density fluctuations in liquid water

Gaia Camisasca1, Daniel Schlesinger2, Iurii Zhovtobriukh1

  • 1Department of Physics, AlbaNova University Center, Stockholm University, S-106 91 Stockholm, Sweden.

Related Concept Videos

States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
56.4K
Water and Mineral Acquisition02:34

Water and Mineral Acquisition

Specialized tissues in plant roots have evolved to capture water, minerals, and some ions from the soil. Roots exhibit a variety of branching patterns that facilitate this process. The outermost root cells have specialized structures called root hairs that increase the root surface, thus increasing soil contact. Water can passively cross into roots, as the concentration of water in the soil is higher than that of the root tissue. Minerals, in contrast, are actively transported into root cells.
35.4K
Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
19.3K
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
5.0K
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
507
The Water Cycle01:00

The Water Cycle

The Earth’s hydrosphere includes all of the areas where the storage and movement of water occurs. Since water is the basis of all living processes, the cycling of water is extremely important to ecosystem dynamics.
28.1K