Temperature change in pulp chamber of primary teeth during curing of coloured compomers: an in vitro study using...

An increase in the temperature of the pulp chamber occurs during polymerisation of all types of light-curing resin-containing restorative materials, due to both the exothermic reaction of the material and the energy absorbed during the curing process. Increase in temperature of the pulp chamber of primary teeth during the curing process or the thermal conductivity properties of coloured compomers (CCs) have not yet been investigated in detail. The aim of the present study was to investigate the increase in pulpal temperature in primary teeth during curing of CCs.

A Class-II cavity was prepared on the extracted primary mandibular second molar. Pulpal microcirculation of the tooth was performed using an experimental mechanism. The study included 15 groups and 10 experiments in each. Seven different CCs: pink, blue, gold, silver, orange, lemon, green, respectively from two different manufacturers (Groups 1-7: Twinky Star; VOCO, Cuxhaven, Germany. Groups 8-14: Nova Rainbow; IMICRYL, Konya, Turkey.) and a tooth-CC (Group 15: Dyract XP; DENTSPLY, Weybridge, UK.) were applied in prepared cavity. In all groups the compomers were light cured for 40 s. Intrapulpal temperature changes (Δt) in 20th and 40th second were recorded. In Group-15 the Δt values in 10th second were also recorded as per the manufacturer's instructions. The Kruskal-Wallis test and the Mann-Whitney-U test were used for statistical analyses.

At the end of 40-s irradiation time, the orange, lemon and green colours of Nova Rainbow resulted in significantly lower Δt values than the same colours of Twinky Star (p = 0.0001), and silver, blue, lemon, green, orange, and pink CCs of Nova Rainbow and the blue and silver shades of Twinky Star demonstrated lower Δt values than the reported critical temperature increase (5.5 °C).

An increase in the irradiation time consequently led to an increase in the intrapulpal temperature. Therefore, manufacturers should focus on production of new CCs with shorter polimerization time.