Related Experiment Video
Updated: Jan 21, 2026

Measurements of Waves in a Wind-wave Tank Under Steady and Time-varying Wind Forcing
Published on: February 13, 2018
Distribution characteristics on droplet deposition of wind field vortex formed by multi-rotor UAV
Shuang Guo1,2, Jiyu Li1,2, Weixiang Yao1,2
1College of Engineering, South China Agricultural University, Guangzhou, China.
Abstract:
When the unmanned aerial vehicle (UAV) is used for aerial spraying, the downwash airflow generated by the UAV rotor will interact with the crop canopy and form a conical vortex shape in the crop plant. The size of the vortex will directly affect the outcome of the spraying operation. Six one-way spraying were performed by the UAV in a rice field with different but random flying altitude and velocities within the optimal operational range to form different vortex patterns. The spraying reagent was clear water, which was collected by water sensitive paper (WSP), and then the WSP was analyzed to study the droplets deposition effects in different vortex states. The results showed that the formation of the vortex significantly influenced the droplet deposition. To be specific, the droplet deposition amount in the obvious-vortex (OV) state was about 1.5 times of that in the small-scale (SV) vortex state, and 7 times of that in the non-vortex (NV) state. In the OV state, the droplets mainly deposited directly below and on both sides of the route. The deposition amount, coverage rate and droplet size increased from top to bottom of the crops with the deposition amount, coverage rate, and volume median diameter (VMD) ranging 0.204-0.470 μL/cm2, 3.31%-7.41%, and 306-367μm, respectively. In the SV state, droplets mainly deposited in the vortex area directly below the route. The deposition amount in the downwind direction was bigger than that in the upwind direction. The maximum of deposition amount, coverage rate and droplet size were found in the middle layer of the crops, the range are 0.177-0.334μL/cm2, 2.71%-5.30%, 295-370μm, respectively. In the NV state, the droplet mainly performed drifting motion, and the average droplet deposition amount in the downwind non-effective region was 29.4 times of that in the upwind non-effective region and 8.7 times of the effective vortex region directly below the route. The maximum of deposition amount, coverage rate and droplet size appeared in the upper layer of the crop, the range are 0.006-0.132μL/cm2, 0.17%-1.82%, 120-309μm, respectively, and almost no droplet deposited in the middle and lower part of the crop. The coefficient of variation (CV) of the droplet deposition amount was less than 40% in the state of obvious-vortex and small-scale vortex, and the worst penetration appeared in the non-vortex amounting to 65.97%. This work offers a basis for improving the spraying performance of UAV.
Related Concept Videos
Three-Winding Transformers
In the per-unit equivalent circuit of a grounded Y-Y three-phase...
Characteristics of Life
Wind Turbine Machine Models
Induction machines interact through the rotating magnetic field generated by the stator and the rotor. The key parameter is slip, which is the difference between synchronous speed and rotor speed relative to synchronous speed. Slip is...
Phase Transitions: Sublimation and Deposition
Characteristics of Fluids
Characteristics of Fluids
Fluids, which include both liquids and gases, are substances that deform continuously under shearing stress. For example, water and oil are liquids with molecules that can...

