Temperature dependence Raman spectroscopy and DFT calculations of Bi2(MoO4)3
G D Saraiva1, J G da Silva Filho2, A Saraiva-Souza3
1Faculdade de Educação Ciências e Letras do Sertão Central, Universidade Estadual do Ceará, CEP 63.902-098 Quixadá, CE, Brazil.
Abstract:
This work reports a theoretical and experimental study on the electronic and vibrational properties of Bi2(MoO4)3. First-principle calculations were applied to increase the understanding on the properties of the chemical composition through the energy bands. The conduction band minimum (CBM) is found at the high symmetric Γ-point, while the valence-band maximum (VBM) is located between the Z and the Γ-points. Therefore, these facts confirm that the Bi2(MoO4)3 crystal is a semiconductor compound with an indirect band-gap of about 2.1 eV. Moreover, lattice dynamic properties were calculated using density functional perturbation theory (DFPT) in order to assign the experimental Raman bands. In addition, we performed temperature-dependent Raman spectroscopic studies in the Bi2(MoO4)3 crystals to obtain information on structural changes induced by effects of the temperature change. From the changes observed in the Raman spectra phase transitions at ∼ 668 and 833 K were inferred, with the last one possibly related to the disorder due to the heating process.
Related Concept Videos
02:55Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
01:20Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
01:12Temperature Dependent Deformation
01:26Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
01:27Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
01:20Relation of DFT to z-Transform
To understand how the DFT works, it's helpful to consider the z-transform, which is a method for representing discrete sequences in the complex frequency domain. The z-transform involves summing the...