68Ga-DOTATATE PET: temporal variation of maximum standardized uptake value in normal tissues and neuroendocrine

George Barberio Coura-Filho1, Ana A F O Hoff1, Paulo S Duarte1

  • 1Division of Nuclear Medicine, Instituto do Câncer do Estado de São Paulo, São Paulo University, School of Medicine, São Paulo, Brazil.

Abstract

Related Concept Videos

Variation: Normal Distribution, Range, and Standard Deviation02:32

Variation: Normal Distribution, Range, and Standard Deviation

In the field of psychology, there are several ways to organize measurements of a trait, feature, or characteristic (i.e., variables). Qualitative data, such as ethnicity, can be tabulated into a frequency count to provide information about the proportion, as well as the variety of groups in a sample or population. On the other hand, researchers can perform a wider set of calculations on quantitative data. The mean, mode, and median, for instance, are central tendency measures to identify a...
27.0K
Maximum Deflection01:13

Maximum Deflection

When analyzing beams under unsymmetrical loads, such as a train moving on a bridge, it is crucial to accurately determine the points of maximum stress and deflection. The process involves identifying the maximum deflection of the beam, which may not always occur at its midpoint due to the uneven distribution of the load.
The maximum deflection occurs at a specific point, known as point O, where the tangent to the deflection curve is horizontal. To find point O, the slope of the tangent at any...
1.0K
What is Variation?01:14

What is Variation?

Apart from the measures of central tendency, distribution, outliers, and the changing characteristics of data with time, an important characteristic of any data set is its variation or spread. In some data sets, the data values are concentrated closely near the mean; in others, the data values are more widely spread out from the mean.
The range, standard deviation, standard error, and variance are the different measures of variation.
Range: The range is the difference between its maximum and...
17.6K
Maximum Power Transfer01:16

Maximum Power Transfer

Numerous practical applications within engineering disciplines, such as telecommunications, necessitate optimizing power delivery to a connected load. This pursuit, however, entails inherent internal losses, which can either equal or exceed the power supplied to the load. The Thevenin equivalent circuit is helpful in finding the maximum power a linear circuit can deliver to a load. It is assumed in this context that the load resistance can be adjusted.
By substituting the entire circuit with...
843
Variation01:19

Variation

An important characteristic of any set of data is the variation in the data. In some data sets, the data values are concentrated closely near the mean; in other data sets, the data values are more widely spread out from the mean. The most common measure of variation, or spread, is the standard deviation, which is the square root of variance.
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
7.7K
Maximum Size of Aggregate01:12

Maximum Size of Aggregate

The maximum size of aggregate is defined as the aperture of the sieve retaining 15 percent or more of the particles present in the aggregate sample. The aggregate's maximum size impacts the concrete's water requirement, workability, and strength. Larger aggregates reduce the surface area needing cement paste coverage, which can lower water needs, thereby allowing a decrease in the water-to-cement ratio when the desired workability and richness of the mix are to be maintained, which can...
528