Related Experiment Video
Updated: Jan 21, 2026

Improving Strength, Power, Muscle Aerobic Capacity, and Glucose Tolerance through Short-term Progressive Strength Training Among Elderly People
Published on: July 5, 2017
Reliability of a Test for Assessment of Isometric Trunk Muscle Strength in Elderly Women
Marceli M A Mesquita1, Marta S Santos2, Alan B S Vasconcelos2
1Department of Physical Education, Federal University of Sergipe, São Cristóvão, Brazil.
Objective:
The aim of this study was to analyze the reproducibility of a protocol using the maximal isometric strength test of the trunk in elderly women aged above 60 years, without low back pain.
Methods:
Twenty-one physically inactive elderly women, who had not engaged in any activity or exercise program in the past three months, participated in the cross-sectional study that consisted of two days of evaluations for the maximal isometric strength of the extensor and flexor muscles of the trunk, with a 48 h interval between the sessions. A platform with fixed seating was used, which allowed the fixation of the hip and lower limbs, with a load cell connected to a linear encoder. To verify the reliability of the test, the interclass correlation coefficient, variation coefficient, minimum detectable difference (MDD), standard error of measurement, and Bland-Altman graphs were calculated.
Results:
No statistical difference was observed between the first and second evaluation, which indicates that there was no learning effect. Interclass correlation coefficient values were classified as very high and high for extensor (0.98) and flexor (0.86) muscles, respectively, besides low variation (9% for both muscle groups) and acceptable values for minimum detectable difference (extensors = 51.1 N, flexors = 48.9 N). In addition, the Bland-Altman analysis revealed low bias and values within the limits of agreement.
Conclusion:
It is concluded that the test of maximum isometric strength of the trunk in healthy and trained elderly people presents high reliability. These values proved to be reliable if performed in at least two evaluation sessions, which confirms the hypothesis of the authors by the consistency of the measurement test.
More Related Videos
Related Concept Videos
Isotonic and Isometric Muscle Contractions
Isotonic contractions
Isotonic contractions occur when a muscle changes length while...
Reliability and Validity
Acid Strength and Molecular Structure
In the absence of any leveling effect, the acid strength of binary compounds of hydrogen with nonmetals (A) increases as the H-A bond strength decreases down a group in the periodic table. For group 17, the order of increasing acidity is HF < HCl < HBr < HI. Likewise, for group 16, the order of increasing acid strength is H2O < H2S < H2Se < H2Te. Across a row in the periodic table, the acid strength of binary hydrogen compounds increases with increasing...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Relation Between Tensile Strength and Compressive Strength of Concrete
The Equilibrium Binding Constant and Binding Strength

