Feasibility study into the potential use of fused-deposition modeling to manufacture 3D-printed enteric capsules in...

The purpose of this work was to investigate the feasibility to manufacture enteric capsules, which could be used in compounding pharmacies, by fused-deposition modeling. It is well-known that conventional enteric dip coating of capsules in community pharmacies or hospitals is a time-consuming process which is characterized by an erratic efficacy. Fused-deposition modeling was selected as a potential 3D printing method due its ease and low-cost implementation. Before starting to print the capsules, an effective sealing system was designed via a computer-aided design program. Hot melt extrusion was used to make printable enteric filaments. They were made of the enteric polymer, a plasticizer and a thermoplastic polymer, namely Eudragit® L100-55, polyethylene glycol 400 and polylactic acid, respectively. Riboflavine-5'-phosphate was selected as a coloured drug model to compare the efficacy of the 3D printed capsules to that of enteric dip coated capsules as they are currently produced in community pharmacies and hospitals. Different parameters of fabrication which could influence the dissolution profile of the model drug, such as the layer thickness or post-processing step, were studied. It was demonstrated that our 3D printed enteric capsules did not release the drug for 2 h in acid medium (pH 1.2). However, they completely dissolved within 45 min at pH 6.8 which allowed the release of a minimal amount of 85% w/w of drug as it was recommended by the European Pharmacopoeia 9th Edition for enteric products.