Related Experiment Video
Updated: Jan 21, 2026

In vitro Induction of Human Dental Pulp Stem Cells Toward Pancreatic Lineages
Published on: September 25, 2021
Human pulp response to conventional and resin-modified glass ionomer cements applied in very deep cavities
Ana Paula Dias Ribeiro1, Nancy Tomoko Sacono2, Diana Gabriela Soares3
1Department of Restorative Dental Sciences, College of Dentistry, University of Florida, 1395 Center Drive, 100405, Gainesville, FL, 32606, USA.
Objectives:
This study assessed the human pulp response after adhesive restoration of cavities by indirect pulp capping with a conventional or a resin-modified glass ionomer cement.
Materials And Methods:
Deep cavities prepared in 26 human premolars were lined with Riva Light Cure (Riva LC), Riva Self Cure (Riva SC), or Dycal, and then restored with composite resin. Four teeth were used as intact control. After time intervals of 7 or 30 days, the teeth were extracted, processed for histological evaluation of the pulp, and the remaining dentin thickness (RDT) between the cavity floor and the pulp was measured.
Results:
At 7 days, a slight pulp inflammation associated with discrete tissue disorganization was observed in most of t the teeth lined with Riva LC and Riva SC. Moderate pulp inflammation occurred in one tooth lined with Riva LC. Bacteria were identified in one specimen of the same group that exhibited no pulp damage. At 30 days, slight pulp inflammation and discrete tissue disorganization persisted in two specimens treated with Riva LC, in which a thin layer of tertiary dentin was deposited. Mean RDTs ranged from 383.0 to 447.8 μm.
Conclusions:
Riva LC produced more damage to the pulp than Riva SC. However, the initial pulp damage decreased over time and after 30 days both GICs were labeled as biocompatible.
Clinical Relevance:
In this study conducted with human teeth, the conventional and the resin-modified glass ionomer cements investigated were shown not to cause post-operative sensitivity or persistent pulp damage when applied as liners in very deep cavities, thereby indicating their biocompatibility.
More Related Videos
08:06A Co-Culture Method to Study Neurite Outgrowth in Response to Dental Pulp Paracrine Signals
Published on: February 14, 2020
14:52Isolation, Characterization and Comparative Differentiation of Human Dental Pulp Stem Cells Derived from Permanent Teeth by Using Two Different Methods
Published on: November 24, 2012
Related Concept Videos
Hydration of Cement
Soundness of Cement
The Looking Glass Self
Portland Cement
Fineness of Cement
Direct...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...