Standardized total tract digestible phosphorus requirement of 24- to 130-kg pigs1,2

A study was conducted to determine the standardized total tract digestible phosphorus (STTD P) requirement for 24- to 130-kg finishing pigs housed under commercial conditions. A total of 1,130 barrows and gilts (PIC 359 × 1050, Hendersonville, TN; initially 24.2 kg) were used, with 26 to 27 pigs per pen with 7 replicates per treatment. Pens of pigs were allotted to treatments in a randomized complete block design with body weight (BW) as the blocking factor. The dietary treatments were fed in 4 phases and were formulated to contain 80%, 90%, 100%, 115%, 130%, and 150% of the National Research Council (NRC) requirement estimate for finishing pigs within each phase. Weight ranges for each phase were: 27 to 49, 49 to 76, 76 to 90, and 90 to 130 kg. Treatments were achieved by increasing the amount of monocalcium phosphate at the expense of corn in the diet with no added phytase. All diets were formulated to contain a similar 1.14:1 to 1.16:1 total Ca:P ratio across treatments in all phases. Increasing STTD P resulted in a quadratic response (P < 0.05) in average daily gain (ADG), gain-to-feed ratio (G:F), and final BW. The greatest improvement was observed with STTD P at 130% of NRC for ADG and final BW and at 115% STTD P for G:F. Average daily feed intake increased linearly (linear, P < 0.05) with the inclusion of STTD P. Increasing STTD P resulted in an increase (quadratic, P < 0.05) in hot carcass weight (HCW) and carcass ADG with the greatest response observed with STTD P at 130% of NRC. There was a marginally significant response (quadratic, P < 0.10) in carcass G:F, with the greatest improvement with STTD P at 115% of NRC. Carcass yield decreased (linear, P < 0.05) with increasing STTD P, while there was a marginally significant (linear, P < 0.10) decrease in backfat and increase in fat-free lean. At the end of the study, a metacarpal was collected and analyzed for bone ash. Increasing STTD P resulted in an increase (linear, P < 0.05) in bone ash weight and percentage ash. For ADG and G:F, the quadratic model demonstrated the best fit. The maximum response in ADG and G:F was estimated at 122% and 116% of NRC STTD P, respectively. The broken-line linear model best fit the data for percentage bone ash, with a plateau achieved at 131% of the NRC STTD P. In conclusion, the estimated STTD P requirement of 24 to 130 kg ranged from 116% to 131% of the NRC publication (2012) requirement estimate.