Comparison of supplemental oxygen delivery by continuous versus demand based flow systems in hypoxemic COPD patients

Rainer Gloeckl1, Inga Jarosch2, Tessa Schneeberger3

  • 1Institute for Pulmonary Rehabilitation Research, Schoen Klinik Berchtesgadener Land, Schoenau am Koenigssee, Germany; Department of Prevention, Rehabilitation and Sports Medicine, Technical University of Munich, Munich, Germany.

Respiratory Medicine
|August 13, 2019
PubMed
Abstract

Related Concept Videos

Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which...
13.1K
Single Pipe Systems01:24

Single Pipe Systems

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...
435
BIBO stability of continuous and discrete -time systems01:24

BIBO stability of continuous and discrete -time systems

System stability is a fundamental concept in signal processing, often assessed using convolution. For a system to be considered bounded-input bounded-output (BIBO) stable, any bounded input signal must produce a bounded output signal. A bounded input signal is one where the modulus does not exceed a certain constant at any point in time.
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system....
892
Blinding01:11

Blinding

Blinding is a commonly used method of not telling participants which treatment a subject is receiving. Blinding is a critical part of a randomized control trial or RCT. It reduces the bias that affects the results. In an RCT, blinding is used in the form of a placebo. A placebo effect occurs when untreated subjects falsely believe they have received the treatment and report improved symptoms. A placebo or a dummy treatment is administered to subjects to negate the bias caused by such an effect.
3.8K
Bioequivalence Experimental Study Designs: Completely Randomized and Randomized Block Designs01:20

Bioequivalence Experimental Study Designs: Completely Randomized and Randomized Block Designs

Body:Bioequivalence experimental study designs are crucial methodologies used in evaluating and comparing the bioavailability of different drug products. These designs are categorized into various types: completely randomized, randomized block, repeated measures, cross and carry-over, and Latin square designs.Completely randomized designs involve randomly allocating treatments to all subjects participating in the experiment. This allocation is achieved by assigning unique random numbers to...
241
COPD: Pathogenesis and Clinical Features01:20

COPD: Pathogenesis and Clinical Features

Chronic obstructive pulmonary disease (COPD) is a group of lung conditions that progressively worsen over time, including chronic bronchitis and emphysema. This cluster of diseases collectively leads to a gradual and irreversible decline in lung function over time.
The primary cause for the onset of COPD is cigarette smoking and exposure to air pollution. These hazardous factors initiate a chain reaction within the lungs, resulting in chronic inflammation, damage to the airways, and a...
1.8K