Related Experiment Video
Updated: Jan 21, 2026

Respirometric Oxidative Phosphorylation Assessment in Saponin-permeabilized Cardiac Fibers
Published on: February 28, 2011
LC-MS analysis of saponins of Achyranthes root in the Japanese market
Kohei Kuwada1, Satoshi Kawase1, Karin Nakata1
1Faculty of Pharmacy, Keio University, 1-5-30 Shibakoen, Minato-ku, Tokyo, 105-8512, Japan.
Abstract:
LC-MS analyses of saponin fractions of Achyranthes roots in the Japanese market revealed that there were three patterns for the saponin fraction of their water extracts, i.e., the saponins with a sugar moiety at position 28 [achyranthosides B (3), C (4) and D (5)] were the major constituents, the saponins without sugar moiety at position 28 [betavulgarosides II (10) and IV (11)] were the major constituents, and mixtures of these saponins. In a decoction prepared from the sample which contained 10 and 11 as the major saponins, their amounts were largely decreased compared with those of the water extract. As large amounts of these saponins were found in the precipitates formed by heating of the water extract, these saponins were seemed to precipitate out under heating. When hot water was used for the extraction, 3, 4 and 5 were detected even from the samples whose water extract did not contain these saponins. This was attributed to inhibition of endogenous esterase which hydrolyzes the ester linkage at position 28. When saponins were extracted with reagent grade 1-butanol, in addition to the decrease of the amounts of highly polar saponins, oxidative decarboxylation of 3 and 10 occurred resulting in formation of achyranthoside E (6) and spinacoside D (12), respectively. As these changes were not observed with HPLC grade 1-butanol, which contain not more than 5 ppm of peroxide impurities, the change was attributable to the peroxide impurities contained in the reagent grade 1-butanol.
Related Concept Videos
Primary and Secondary Growth in Roots and Shoots
Root Mean Square
For example, consider the velocity of gas molecules in a container. The gas molecules are moving in different directions, which might impart positive and negative...
Root-Locus Method
This system can be represented by a block...
Construction of Root Locus
For positive gain values, the root locus exists on the real axis to the left of an odd number of finite open-loop poles or zeros. The root locus starts at the open-loop poles and traces the paths of the closed-loop poles as the gain...
Properties of the Root Locus
To determine if a point lies on the root locus, the criterion involves the sum of angles contributed by all poles and zeros to that point. Specifically, this sum must be an odd multiple of 180 degrees. The gain at any point on...
Plotting and Calibrating the Root Locus
The maximum gain occurs at the breakaway points between open-loop poles on the real axis, while the minimum gain is...

