Related Experiment Video
Updated: Jan 20, 2026
An Experimental Paradigm for the Prediction of Post-Operative Pain PPOP
Published on: January 27, 2010
Effect of Intrapleural Meperidine on Post-Operative Pain after Open Cholecystectomy
Kamran Mottaghi1, Farhad Safari1, Parisa Sezari1
1Anesthesiology Research Center, Department of Anesthesiology, Shahid Beheshti University of Medical Sciences, Tehran, Iran.
Background:
Post-operative pain after open cholecystectomy can result in increased oxygen consumption, atelectasis, pneumonia, decreased vital capacity, and increased morbidity and mortality. The aim of this study was to compare the analgesic effects of intrapleural meperidine and intravenous morphine in controlling post-cholecystectomy pain.
Materials And Methods:
In a double-blinded randomized clinical trial, 72 patients who were candidate for elective open cholecystectomy, were divided randomly into two groups based on accidental randomized numbers. Anesthesia technique was precisely the same for all patients. At the end of surgery, 50 mg of meperidine (diluted in 20 cc normal saline) was injected intrapleurally for meperidine group patients; whereas, 0.1 mg/kg intravenous morphine was injected intravenously in control group. Onset of pain and total dose of rescue analgesic were measured.
Results:
In order to obtain a Numerical Rating Scale (NRS) <3, the difference in morphine consumption up to 12 hours in two groups (4.4 ±1.7 mg in meperidine group & 5±2 mg in control group) was not statistically different. However, the first request for analgesia in meperidine group was delayed significantly longer than the control group (146.6 ±6.8 minutes in meperidine group & 40 ±1.8 minutes in control group).
Conclusion:
A single injection of intrapleural meperidine can delay the first request for analgesia in open cholecystectomy compared to intravenous morphine.
Related Concept Videos
01:28Cardiomyopathy VII: Pre and Post Operative Nursing Management
01:20Pain
01:17Operational Amplifiers
01:20Vector Operations
A vector multiplied by a scalar value is called scalar multiplication. The result obtained is a new vector with a different magnitude. If the scalar is positive, the direction of the vector remains the same, but if it is negative, the direction of the vector is reversed. For example, the product of the mass and velocity yields the momentum.
01:21Operant Conditioning
Reinforcement in operant conditioning can be positive or negative, both of which serve to increase the likelihood of a behavior. Positive...
01:21Modes of Operations of BJT
Active Mode: The most common mode for amplification, the active mode features a forward-biased emitter-base junction and a reverse-biased base-collector junction. This setup enables electrons to be injected from the emitter to the base while blocking the majority carriers at the collector. The...