A biomechanical study of the relationship between running velocity and three-dimensional lumbosacral kinetics

Faster running is not performed with proportional increase in all joint torque/work exertions. Although previous studies have investigated lumbopelvic kinetics for a single velocity, it is unclear whether each lumbopelvic torque should increase for faster running. We examined the relationship between running velocity and lumbopelvic kinetics. We calculated the three-dimensional lumbosacral kinetics of 10 male sprinters during steady-state running on a temporary indoor running track at five target velocities: 3.0 (3.20 ± 0.16), 4.5 (4.38 ± 0.18), 6.0 (5.69 ± 0.47), 7.5 (7.30 ± 0.41), and maximal sprinting (9.27 ± 0.36 m/s). The lumbosacral axial rotation torque increased more markedly (from 0.37 ± 0.06 to 1.99 ± 0.46 Nm/kg) than the extension and lateral flexion torques. The increase in the axial rotation torque was larger above 7.30 m/s. Conversely, the extension and lateral flexion torques plateaued when running velocity increased above 7.30 m/s. Similar results were observed for mechanical work. The results indicate that faster running required larger lumbosacral axial rotation torque. Conversely, the extension and lateral flexion torques were relatively invariant to running velocity above 7 m/s, implying that faster running below 7 m/s might increase the biomechanical loads causing excessive pelvic posterior tilt and excessive pelvic drop which has the potential to cause pain/injury related to lumbopelvic extensors and lateral flexors, whereas these biomechanical loads might not relate with running velocity above 7 m/s.