Related Experiment Video
Updated: Jan 20, 2026

Author Spotlight: The Box-Cavity Cortical Approach for Enhanced Evaluation of Biomaterials and Bone Regeneration
Published on: November 21, 2023
Bioceramic cement in the filling of bone defects in rats
Christiano Cândido Zerbinatti1, Daniela Francescato Veiga2, Monique Amanda Bastista Oliveira3
1DDS, Master, Professional Masters in Sciences Applied to Health, Universidade Vale do Sapucaí (UNIVÁS), Pouso Alegre-MG, Brazil. Conception and design of the study; acquisition, analysis and interpretation of data; manuscript preparation.
Purpose:
To evaluate PBS®MCIMMO cement in the filling of bone defects.
Methods:
Thirty-six adult male Wistar rats were divided into three groups of twelve individuals each (group 1, group 2 and group 3). In all groups, a bone failure in the femur was induced, 2.0 mm wide and 7.0 mm deep. In group 1, the PBS®MCIMMO cement was applied to the bone defect produced and a titanium implant (CONNECTION®) 1.5 mm thick and 6 mm long was installed. In group 2, only the PBS® CIMMO cement was installed. In group 3, only bone failure was performed. Kruskal Wallis tests were performed to compare the mean area among the three groups.
Results:
In all comparisons, significance was observed for group 2 (p = 0.0014-0.0026).
Conclusion:
The PBS®CIMMO cement induced bone neoformation, and integration between the newly formed bone, cement, and implant was observed.
Related Concept Videos
Hydration of Cement
Soundness of Cement
Portland Cement
Fineness of Cement
Direct...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...

