Phase I Safety Trial: Extended Daily Peripheral Sensory Stimulation Using a Wrist-Worn Vibrator in Stroke Survivors

Na Jin Seo1, Leah R Enders2, Andrew Fortune3

  • 1Division of Occupational Therapy, Department of Health Professions, Department of Health Sciences and Research, Medical University of South Carolina (MUSC), Charleston, SC, USA. seon@musc.edu.

Related Concept Videos

Action Potential: Phases of Stimulation01:28

Action Potential: Phases of Stimulation

The action potential is a complex electrical event that occurs in excitable cells, such as neurons and muscle cells. It consists of several distinct phases, each with specific characteristics.
Resting Phase:
In this phase, the cell's membrane is at its resting potential, typically around -70 millivolts (mV) for neurons. Inside the cell, there is a higher concentration of potassium ions (K+) and a lower concentration of sodium ions (Na+). Voltage-gated sodium channels are closed, and...
11.7K
What is a Sensory System?01:31

What is a Sensory System?

Sensory systems detect stimuli—such as light and sound waves—and transduce them into neural signals that can be interpreted by the nervous system. In addition to external stimuli detected by the senses, some sensory systems detect internal stimuli—such as the proprioceptors in muscles and tendons that send feedback about limb position.
100.8K
Survey Safety01:28

Survey Safety

Surveying near highways, rough terrain, or power lines involves significant risks. Working along highways is particularly dangerous and requires the use of warning signs and flagmen. It is safest to avoid working directly on roads and use offsets whenever possible. When highway work is unavoidable, it must follow all safety guidelines. Surveyors should wear bright clothing, such as orange reflective vests, to ensure visibility to motorists, coworkers, and hunters. In construction zones, wearing...
373
Vibrating Concrete01:19

Vibrating Concrete

Mechanical vibrators are instrumental in compacting newly poured concrete within formwork and around reinforcements. This process is essential to eliminate trapped air pockets and establish a dense concrete mass. One widely used method is vibrating by internal vibrators, often referred to as a poker vibrator or immersion vibrator. It is rapidly inserted through the full depth of the freshly laid concrete and slightly extends into the layer below it (which remains in a plastic state). Consistent...
379
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
14.6K
Clinical Trials01:16

Clinical Trials

Clinical trials are prospective experimental studies conducted on humans to determine the safety and efficacy of treatments, drugs, diet methods, and medical devices. Using statistics in clinical trials enables researchers to derive reasonable and accurate conclusions from the collected data, allowing them to make wise decisions in uncertain situations. In medical research, statistical methods are crucial for preventing errors and bias.
There are four phases in a clinical trial. A phase one...
10.2K