Relationships Between Allopurinol Dose, Oxypurinol Concentration and Urate-Lowering Response-In Search of a Minimum
Lisa K Stamp1,2, Peter T Chapman2, Murray Barclay1
1Department of Medicine, University of Otago, Christchurch, New Zealand.
Abstract:
The aims of this study were to determine factors that predict serum urate (SU) lowering response to allopurinol and the conversion of allopurinol to oxypurinol, and to determine a minimum therapeutic oxypurinol concentration. Data from 129 participants in a 24-month open, randomized, controlled, parallel-group, comparative clinical trial were analyzed. Allopurinol dose, SU, and plasma oxypurinol concentrations were available at multiple time points. The slope for the association between allopurinol dose and SU was calculated as a measure of sensitivity to allopurinol. The slope for the association between allopurinol dose and oxypurinol was calculated as a measure of allopurinol metabolism. Receiver operating characteristic (ROC) curves were used to identify a minimum oxypurinol concentration predictive of SU < 6 mg/dL. There was a wide range of SU concentrations for each allopurinol dose. The relationship between sensitivity to allopurinol and allopurinol metabolism for each 100 mg allopurinol dose increase varied between individuals. Body mass index (P = 0.023), creatinine clearance (CrCL; P = 0.037), ABCG2 Q141K (P = 0.019), and SU (P = 0.004) were associated with sensitivity to allopurinol. The minimum oxypurinol concentration for achieving the urate target was found to be about 104 μmol/L, but predictive accuracy was poor (ROC curve area under the curve (AUC) 0.65). The minimum therapeutic oxypurinol concentration was found to increase with decreasing renal function. Although there is a positive relationship between change in oxypurinol and change in SU concentration, a minimum therapeutic oxypurinol is dependent on CrCL and cannot reliably predict SU target. Other variables, including ABCG2 Q141K genotype, impact on sensitivity to allopurinol (ACTRN12611000845932).
Related Concept Videos
Determination of Multiple Dosing Parameters: Steady-State, Minimum and Maximum Concentrations
Dose-Response Relationship: Overview
Radical Reactivity: Concentration Effects
Dose-Response Relationship: Potency and Efficacy
Dose-Response Relationship: Selectivity and Specificity
Concentration and Rate Law
For example, in a generic reaction aA + bB ⟶ products, where a and b are stoichiometric coefficients, the rate law can be written as:


