Related Experiment Video

Updated: Jan 20, 2026

Reverse Total Shoulder Arthroplasty
10:10

Reverse Total Shoulder Arthroplasty

Published on: July 5, 2011

43.8K

Evaluation of information available on the internet regarding reverse total shoulder arthroplasty

Darby A Houck1, Matthew J Kraeutler1, John W Belk1

  • 1University of Colorado School of Medicine, Department of Orthopedics, Aurora, CO, USA.

Shoulder & Elbow
|August 27, 2019
PubMed
Abstract

Keywords:
Internetconsumer health informationevaluation studiesinformation disseminationreverse total shoulder arthroplastysearch engine

More Related Videos

Individualized Stem-positioning in Calcar-guided Short-stem Total Hip Arthroplasty09:31

Individualized Stem-positioning in Calcar-guided Short-stem Total Hip Arthroplasty

Published on: February 27, 2018

12.4K
Rat Model of Adhesive Capsulitis of the Shoulder04:46

Rat Model of Adhesive Capsulitis of the Shoulder

Published on: September 28, 2018

7.9K

Related Concept Videos

Muscles of the Shoulder01:23

Muscles of the Shoulder

The muscles surrounding the shoulder girdle, including the clavicle and scapula, primarily stabilize the scapula. This stable base allows other muscles to move the humerus effectively. Scapular movements often mirror those of the humerus and extend its range of motion. For instance, raising the arm above the head would not be feasible without simultaneous upward rotation of the scapula.
Anterior Thoracic Muscles
The anterior thoracic muscles include the serratus anterior, subclavius, and...
9.0K
Diode: Reverse bias01:14

Diode: Reverse bias

A diode is reverse-biased when the positive terminal of an external voltage source is connected to the n-type material and the negative terminal to the p-type material. This configuration opposes the natural direction of current flow through the diode, effectively increasing the width of the depletion region and the barrier potential. The reverse bias condition produces a minimal leakage current, primarily due to minority charge carriers. This leakage becomes significant when the reverse...
1.8K
Reversible and Irreversible Processes01:14

Reversible and Irreversible Processes

The thermodynamic processes can be classified into reversible and irreversible processes. The processes that can be restored to their initial state are called reversible processes. It is only possible if the process is in quasi-static equilibrium, i.e., it takes place in infinitesimally small steps, and the system remains at equilibrium However, these are ideal processes and do not occur naturally. An ideal system undergoing a reversible process is always in thermodynamic equilibrium within...
5.6K
Total Voids in Concrete01:12

Total Voids in Concrete

Total voids in concrete encompass gel water volume, capillary pores, and entrapped air. Gel water (retained within the cement hydration products) and physically entrapped or adsorbed water are significant for the hydration process. For complete hydration, it's estimated that the space needed for the products of a cubic centimeter of cement doubles. Capillary pores constitute the unoccupied space within the hydrated cement paste, with their size largely influenced by the water-to-cement...
453
Total Internal Reflection Fluorescence Microscopy01:05

Total Internal Reflection Fluorescence Microscopy

Total internal reflection fluorescence microscopy or TIRF is an advanced microscopic technique used to visualize fluorophores in samples close to a solid surface with a higher refractive index, such as a glass coverslip. TIRF only allows fluorophores in proximity to the solid surface to be excited. When light from a medium with a lower refractive index (such as air) hits the glass coverslip at a critical angle, the light undergoes total internal reflection stead of passing through the glass.
11.0K
Modeling of Diode Reverse Characteristics01:14

Modeling of Diode Reverse Characteristics

In electronic circuits, reverse-biased diode configurations are critical for regulating voltage levels. Zener diodes exploit the reverse breakdown phenomenon and exhibit a controlled breakdown at a specific Zener voltage (VZ). They are designed to maintain a constant voltage across their terminals and are commonly used for voltage regulation in circuits.
When a reverse voltage applied to a Zener diode exceeds its breakdown voltage, the diode enters the breakdown region. At this point, the...
611