Related Experiment Video
Updated: Jan 20, 2026

Endaural Endoscopic Atticoantrotomy Retrograde Mastoidectomy using a Constant Suction Bone-drilling Technique
Published on: May 23, 2021
Utilization of incus with bone cement for total ossicular reconstruction
1Department of Otorhinolaryngology, Faculty of Medicine, Recep Tayyip Erdogan University , Rize , Turkey.
Abstract:
Background: Total ossicular chain reconstructions are performed to connect mobile stapes footplate and tympanic membrane. Data on the use of incus for total ossicular reconstruction is quite limited in the literature. Objective: The main objective of this study is to describe a novel surgical method that utilizes incus with bone cement to stabilize the ossicular chain for total ossicular reconstruction. Materials and methods: 16 patients who underwent total ossicular reconstruction using our method were included in this study. We evaluated hearing by comparing preoperative and postoperative air-bone gap (ABG), air conduction (AC) and bone conduction (BC). The percentage of patients achieving ABG ≤20 dB was determined. Results: The mean preoperative ABG was 35.3 ± 8.2 and postoperative ABG decreased significantly to 23.7 ± 7.6 (p < .001). The mean preoperative AC (57.5 ± 10) decreased significantly postoperatively to (46.5 ± 13.3)(p = .014). There was not any difference between pre- and post-operative BC. We achieved successful hearing results (ABG ≤ 20dB) in 44% of patients. Conclusion: The use of incus with bone cement stabilization for total ossicular reconstruction seems a feasible option. Good hearing outcomes, and low cost, complication, and extrusion rate may be the main reasons to prefer this method.
Related Concept Videos
Hydration of Cement
Soundness of Cement
Portland Cement
Fineness of Cement
Direct...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...

