Related Experiment Video
Updated: Jan 20, 2026

Shaping the Amplitude and Phase of Laser Beams by Using a Phase-only Spatial Light Modulator
Published on: January 28, 2019
Sub-second infrared broadband-laser single-shot phase-amplitude polarimetry of thin films
Abstract:
We report on the first, to the best of our knowledge, sub-second, sub-mm2 infrared (IR) spectroscopic measurements of thin organic films employing a laser-based phase-amplitude polarimeter in reflection geometry. The polarimeter uses a broadband mid-IR quantum cascade laser tunable between 1318 cm-1 and 1765 cm-1, as well as a single-shot beam division scheme for simultaneous single-pulse phase and amplitude measurements. The instrument achieves 120 μm spatial and <0.5 cm-1 spectral resolution, while providing unrivaled performance in terms of acquisition times. Spectral measurements within 100 ms and single-wavelength tracking at 16 μs are now possible. Investigating the vibrational properties accessible in the mid-IR, the polarimeter was applied for monitoring changes in molecular interactions of a 150 nm thin myristic acid film during its thermal phase transition around 55°C.
Related Concept Videos
08:39Shaping the Amplitude and Phase of Laser Beams by Using a Phase-only Spatial Light Modulator
09:38Characterizing Far-infrared Laser Emissions and the Measurement of Their Frequencies
Single Phase Inverter
DC power is unidirectional and flows in one direction, whereas, AC current alternates directions at a frequency of 50-60 Hz. Most common electronic devices are designed to run off of AC power; therefore an input DC source must be inverted to AC. Inverters convert DC voltage to AC through switching action that repeatedly flips the polarity of the input DC source at the output or load side for part of...
Inductance: Single-Phase And Three-Phase Line
Single-Phase Two-Wire Line:
A single-phase line consists of two solid cylindrical conductors, denoted as x and y. Each conductor carries phasor currents ix and iy, respectively. Given that the sum of these currents is...
Capacitance: Single-Phase And Three-Phase Line
Single-Phase Lines
Consider a single-phase, two-wire transmission line with equal phase spacing energized by a voltage source. One conductor carries a uniform positive charge, while the other carries an equal negative charge. The capacitance C of the line can be derived from the voltage V between the conductors. For a one-meter section of the line, the capacitance is given...
11:04Control of Cell Geometry through Infrared Laser Assisted Micropatterning
