Multiple platelet-rich plasma preparations can solubilize freeze-dried chitosan formulations to form injectable...

Platelet-rich plasma (PRP) has been used to solubilize freeze-dried chitosan (CS) formulations to form injectable implants for tissue repair.

To determine whether the in vitro performance of the formulations depends on the type of PRP preparation used to solubilize CS.

Formulations containing 1% (w/v) CS with varying degrees of deacetylation (DDA 80.5-84.8%) and number average molar mass (Mn 32-55 kDa), 1% (w/v) trehalose and 42.2 mM calcium chloride were freeze-dried. Seven different PRP preparations were used to solubilize the formulations. Controls were recalcified PRP.

CS solubilization was achieved with all PRP preparations. CS-PRP formulations were less runny than their corresponding PRP controls. All CS-PRP formulations had a clotting time below 9 minutes, assessed by thromboelastography, while the leukocyte-rich PRP controls took longer to coagulate (>32 min), and the leukocyte-reduced PRP controls did not coagulate in this dynamic assay. In glass culture tubes, all PRP controls clotted, expressed serum and retracted (43-82% clot mass lost) significantly more than CS-PRP clots (no mass lost). CS dispersion was homogenous within CS-PRP clots.

In vitro performance of the CS-PRP formulations was comparable for all types of PRPs assessed.