Comparison of the adsorption behaviors for methylene blue on two renewable gels with different physical state

High removal efficiency and excellent recyclability are the fundamental qualities that an outstanding adsorbent used for organic dye removal should possess. In this study, two recyclable gels (sodium alginate/Ca/fiber: SCFA hydrogels; cellulose nanofiber/chitosan: CNFCS aerogels) were successfully fabricated using the facile method. Additionally, the as-prepared adsorbents were investigated using a series of characterizations. The adsorption behavior and anti-interference performance of the synthesized gels were compared by choosing methylene blue (MB) as the model pollutant. The kinetic behavior of the gels towards MB was consistent with the pseudo first-order model, and the SCFA hydrogels reached adsorption equilibrium faster than the CNFCS aerogels. The maximum adsorption capacity of MB on the SCFA hydrogels and CNFCS aerogels was 1335.0 and 164.5 mg g^-1 (pH = 7.0, dosage: 0.5 g/L; initial concentration from 15 to 180 mg L^-1), respectively. More specifically, we found that the co-existing anions had different effects on MB adsorption over the gels used for MB removal. Furthermore, for the SCFA hydrogels, co-existing natural organic matter (NOM) at low concentrations enhanced MB adsorption, and then stabilized as the concentration of NOM increased. However, this increasing trend was not observed for MB adsorption on CNFCS aerogels; these gels exhibited a slight decrease at first, and then showed no change. Nevertheless, both the gels exhibited superior regeneration and recycling abilities.