Polyurethane Aerogels Based on Cyclodextrins: High-Capacity Desiccants Regenerated at Room Temperature by Reducing...

Polyurethane aerogels were prepared from a rigid aromatic triisocyanate (tris(4-isocyanatophenyl)methane) and cage-shaped α- and β-cyclodextrins as rigid polyols. Gelation was carried out in DMF using dibutyltin dilaurate as catalyst. Wet-gels were dried to aerogels (abbreviated as α- or β-CDPU-xx) with supercritical fluid CO₂. "xx" stands for the percent weight of the two monomers in the sol and was varied at two levels for each cyclodextrin: 2.5% and 15%. All aerogels were characterized with solid-state ¹³C and ¹⁵N NMR, CHN analysis, FTIR, XPS, SEM, and gas (N₂ and CO₂) sorption porosimetry. α- and β-CDPU-xx aerogels were investigated as desiccants at room temperature. All materials had relatively higher capacities for water adsorption from high-humidity environments (99%) than typical commercial desiccants like silica or Drierite. However, α-CDPU-2.5 aerogels did stand out with a water uptake capacity reaching 1 g of H₂O per gram of material. Most importantly though, adsorbed water could be released quantitatively without heating, by just reducing the relative humidity of the environment to 10%. All α- and β-CDPU-xx aerogel samples were cycled between humid and dry environments 10 times. Their unusual behavior was traced to filling smaller mesopores with water and was attributed to a delicate balance of enthalpic (H-bonding) and entropic factors, whereas the latter are a function of pore sizes.