An approach to study the inter-relationship between mechanical and durability properties of ternary blended cement

Sakthieswaran Natarajan1, Shiny Brintha Gnanadurai1

  • 1Department of Civil Engineering, Anna University Regional Campus, Tirunelveli-627007, Tamilnadu, India.

Related Concept Videos

Tests on Fresh Concrete11:23

Tests on Fresh Concrete

Source: Roberto Leon, Department of Civil and Environmental Engineering, Virginia Tech, Blacksburg, VA
Concrete consists of two phases, a cement paste phase comprised of cement, water, and air, and an aggregate phase comprised of coarse and fine aggregates. There are two key considerations when designing a concrete mix. First, the concrete must be workable and easy to cast in the forms in its fresh condition, even when the forms are packed with steel reinforcement. In this condition, it is...
27.0K
A Testing Platform for Durability Studies of Polymers and Fiber-reinforced Polymer Composites under Concurrent Hygrothermo-mechanical Stimuli07:15

A Testing Platform for Durability Studies of Polymers and Fiber-reinforced Polymer Composites under Concurrent Hygrothermo-mechanical Stimuli

The durability of polymers and fiber-reinforced polymer composites in service is a critical aspect for their designs and condition-based maintenance. We present a novel low-cost laboratory testing platform for the investigation of the influence of concurrent mechanical and environmental loadings, and may help design more efficient yet safer composite...
14.2K
Determination of the Mechanical Properties of Flexible Connectors for Use in Insulated Concrete Wall Panels05:26

Determination of the Mechanical Properties of Flexible Connectors for Use in Insulated Concrete Wall Panels

We propose a testing protocol that can be combined with widely available analytical methods to assess the mechanical properties of shear connectors for use in the design of insulated concrete wall panels to predict full-scale insulated panel...
2.0K
Determination of Self- and Inter-(in)compatibility Relationships in Apricot Combining Hand-Pollination, Microscopy and Genetic Analyses08:08

Determination of Self- and Inter-(in)compatibility Relationships in Apricot Combining Hand-Pollination, Microscopy and Genetic Analyses

We present a methodology to establish the pollination requirements of apricot (Prunus armeniaca L.) cultivars combining the determination of self-(in)compatibility by fluorescence microscopy with the identification of the S-genotype by PCR...
7.8K
Aggregates for Concrete and Asphaltic Mixes10:10

Aggregates for Concrete and Asphaltic Mixes

Source: Roberto Leon, Department of Civil and Environmental Engineering, Virginia Tech, Blacksburg, VA
Concrete and asphalt are by far the most common construction materials used today. Concrete is a composite material consisting of cement, water, air, coarse aggregate, and fine aggregates. Fine aggregates are typically sands and coarse aggregates are natural or crushed rocks. Chemical admixtures to modify certain specific properties are also commonly used (i.e., superplasticizers to make...
13.2K
Thermochemical Studies of Ni(II) and Zn(II) Ternary Complexes Using Ion Mobility-Mass Spectrometry16:11

Thermochemical Studies of Ni(II) and Zn(II) Ternary Complexes Using Ion Mobility-Mass Spectrometry

This article describes an experimental protocol using electrospray-ion mobility-mass spectrometry, semi-empirical quantum calculations, and energy-resolved threshold collision-induced dissociation to measure the relative thermochemistry of the dissociation of related ternary metal...
2.7K