Simultaneous influence of additive and multiplicative noise on stationary dissipative solitons

Carlos Cartes1, Orazio Descalzi1,2, Helmut R Brand2

  • 1Complex Systems Group, Facultad de Ingeniería y Ciencias Aplicadas, Universidad de los Andes, Av. Mons. Álvaro del Portillo 12.455, Las Condes, Santiago, Chile.

Physical Review. E
|September 11, 2019
PubMed

Related Concept Videos

Characterizing Dissipative Elastic Metamaterials Produced by Additive Manufacturing09:39

Characterizing Dissipative Elastic Metamaterials Produced by Additive Manufacturing

Additively manufactured polymers have been widely used for producing elastic metamaterials. The viscoelastic behavior of these polymers at ultrasonic frequencies remains, however, poorly studied. This study reports a protocol to estimate the viscoelastic properties of 3D-printed polymers and show how to use them to analyze the metamaterial dynamics.
1.5K
Rapid Repetition Rate Fluctuation Measurement of Soliton Crystals in a Microresonator07:42

Rapid Repetition Rate Fluctuation Measurement of Soliton Crystals in a Microresonator

Here, we present a protocol to generate soliton crystals in a butterfly-packaged micro-ring resonator using a thermal tuned method. Further, the repetition rate fluctuations of a soliton crystal with a single vacancy are measured using a delayed self-heterodyne...
3.5K
Simultaneous Cryosectioning of Multiple Rodent Brains06:37

Simultaneous Cryosectioning of Multiple Rodent Brains

Here, we present a protocol to freeze and section brain tissue from multiple animals as a timesaving alternative to processing single brains. This reduces staining variability during immunohistochemistry and reduces time cryosectioning and...
24.8K
Conjugate Addition (1,4-Addition) vs Direct Addition (1,2-Addition)01:27

Conjugate Addition (1,4-Addition) vs Direct Addition (1,2-Addition)

α,β-Unsaturated carbonyl compounds with two electrophilic sites, the carbonyl carbon, and the β carbon, are susceptible to nucleophilic attack via two modes: conjugate or 1,4-addition and direct or 1,2-addition.
Conjugate addition results in a thermodynamically stable product. The reaction retains the stronger C=O bond at the expense of the weaker C=C π bond. The process is slow as the β carbon is less electrophilic than the carbonyl carbon.
Direct addition products are...
4.2K
Power Dissipated in a Circuit: Problem Solving01:15

Power Dissipated in a Circuit: Problem Solving

The equivalent resistance of a combination of resistors depends on their values and how they are connected.
The simplest combinations of resistors are series and parallel connections. In a series circuit, the first resistor's output current flows into the second resistor's input; therefore, each resistor's current is the same. Thus, the equivalent resistance is the algebraic sum of the resistances. The current through the circuit can be found from Ohm's law and is equal to the...
1.6K
Dissipative Microgravimetry Technique to Study Protein-Lipid Bilayer Interaction03:36

Dissipative Microgravimetry Technique to Study Protein-Lipid Bilayer Interaction

This video demonstrates a dissipative microgravimetry technique to investigate the binding of proteins to lipid bilayers. Small unilamellar vesicles are added to coat the surface of the quartz sensor of a microbalance. Utilizing the calcium ion-dependent binding of the target phospholipid-binding protein to the bilayer, changes in the oscillation frequency of the sensor and the dissipation of the oscillation are monitored to determine the nature of the protein-lipid bilayer...
475