Related Experiment Video
Updated: Jan 19, 2026
Measuring Turbulent Flows Using Hot-Wire Anemometers
Published on: April 30, 2023
Calculating structure function constant from measured Cn 2 in non-Kolmogorov and anisotropic turbulence including
Abstract:
Optical scintillometers used to characterize turbulence are based on assumptions of isotropic, Kolmogorov turbulence following a κ-11/3 spectral power law. However, experimental data suggest that the turbulence may at times be anisotropic and non-Kolmogorov. In this work, consideration is given to converting from the structure function constant, Cn2, based on isotropic, Kolmogorov statistics to its generalized anisotropic, non-Kolmogorov form, C˜n2, for point receiver and large-aperture receiver scintillometers. It is found that C˜n2 is dependent not only on power law and anisotropy parameters but that it is also a function of inner scale. The large-aperture scintillometer is found to be less sensitive to power law and inner scale than the point-aperture receiver. The optical parameters of two-fielded scintillometers are modeled as practical examples of these behaviors.
Related Concept Videos
Measuring Turbulent Flows
Turbulent flows exhibit very high frequency fluctuations that require instruments with high time-resolution for their appropriate characterization. Hot-wire anemometers have a short enough time-response to fulfill this requirement. The purpose of this experiment is to demonstrate the use of hot-wire anemometry to characterize a turbulent jet.
In this...
Calculating the Equilibrium Constant
For example, gaseous nitrogen dioxide forms dinitrogen tetroxide according to this equation:
Constant Temperature Anemometry: A Tool to Study Turbulent Boundary Layer Flow
A boundary layer is a thin flow region immediately adjacent to the surface of a solid body immersed in flow field. In this region, viscous effects, such as the viscous shear stress, dominate, and the flow is retarded due to the influence of friction between the fluid and the solid surface. Outside of the boundary layer, the flow is inviscid, i.e.,...
12:34Methods for Measuring the Orientation and Rotation Rate of 3D-printed Particles in Turbulence
10:19A CO2 Concentration Gradient Facility for Testing CO2 Enrichment and Soil Effects on Grassland Ecosystem Function
Turbulence Sphere Method: Evaluating Wind Tunnel Flow Quality
Wind tunnel tests are useful in the design of vehicles and structures that are subjected to airflow during their use. Wind tunnel data are generated by applying a controlled air flow to a model of the object being studied. The test model usually has a similar geometry but is a smaller scale compared to the full-sized object. To ensure accurate and useful data is collected...