Testing lenses and reflecting concave surfaces using a knife-edge interferometer

The full process from brain specimen preparation to serial sectioning imaging using the Knife-Edge Scanning Microscope, to data visualization and analysis is described. This technique is currently used to acquire mouse brain data, but it is applicable to other organs, other...

Source: Derek Wilson, Asantha Cooray, PhD, Department of Physics & Astronomy, School of Physical Sciences, University of California, Irvine, CA
Light travels at different speeds depending on the material through which it is propagating. When light travels from one material to another, it will either slow down or speed up. In order to conserve energy and momentum, the light must change the direction in which it propagates. This bending of light is known as refraction. Some fraction of...

A reference interferometer technique, which is designed to remove undesirable laser jitter noise for nanodetection, is utilized for probing an ultra-high quality factor microcavity. Instructions for assembly, setup, and data acquisition are provided, alongside the measurement process for specifying the cavity quality...

Procedures used to generate microstructured concave-porosity polydimethylsiloxane beads are presented. Effects of electrolyte concentration and identity within the aqueous phase are particularly emphasized.

Current in vitro models for evaluating contact lenses (CLs) and other eye-related applications are severely limited. The presented ocular platform simulates physiological tear flow, tear volume, air exposure and mechanical wear. This system is highly versatile and can be applied to various in vitro analyses with...

This manuscript introduces a robust method of fabricating concave microwells without the need for complex high-cost facilities. Using magnetic force, steel beads, and a through-hole array, several hundred microwells were formed in a 3 cm x 3 cm polydimethylsiloxane (PDMS)...