Correction of Vertical Smile Discrepancy through Ceramic Laminate Veneers and Surgical Crown Lengthening

Paula Bernardon1, Carlos Estevão Lagustera1, Luiz Roberto Coutinho Manhães Junior2

  • 1West State University of Parana, No. 1618 Universitária St., Cascavel, PR 85819-110, Brazil.

Case Reports in Dentistry
|September 13, 2019
PubMed

Related Concept Videos

Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material07:42

Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material

A quasistatic load-to-fracture test with a non-fixed stainless steel ball was developed to determine the fracture strength of minimally invasive posterior computer-aided design and manufacturing restorations cemented to dentin analog materials. This test models the typical loading regime responsible for the fracture of dental...
772
Self-Discrepancy Theory02:45

Self-Discrepancy Theory

One influential perspective on what motivates people's behavior is detailed in Tory Higgin's self-discrepancy theory (Higgins, 1987). He proposed that people hold disagreeing internal representations of themselves that lead to different emotional states.  
18.9K
Surgical Correction for Pediatric Epiblepharon and Trichiasis03:59

Surgical Correction for Pediatric Epiblepharon and Trichiasis

Here, we present a protocol for surgical correction for pediatric epiblepharon and...
526
Veneer01:19

Veneer

Veneer refers to a thin sheet of wood, typically produced to a thickness of about one-eighth of an inch or less. This material is crafted through various methods, the most common being rotary cutting. In this process, a log is mounted into a large lathe and spun against a knife edge, peeling off a continuous strip of wood as the knife penetrates deeper into the rotating log, creating a rotary-cut veneer.
Other veneering techniques include plain-slicing, quarter-slicing, and rift-slicing. These...
369
Multi-material Ceramic-Based Components – Additive Manufacturing of Black-and-white Zirconia Components by Thermoplastic 3D-Printing (CerAM - T3DP)08:29

Multi-material Ceramic-Based Components – Additive Manufacturing of Black-and-white Zirconia Components by Thermoplastic 3D-Printing (CerAM - T3DP)

Here we describe a protocol for additively manufacturing black-and-white zirconia components by Thermoplastic 3D-Printing (CerAM - T3DP) and co-sintering...
11.8K
Fused Filament Fabrication (FFF) of Metal-Ceramic Components08:43

Fused Filament Fabrication (FFF) of Metal-Ceramic Components

This study shows multi-material additive manufacturing (AM) using fused filament fabrication (FFF) of stainless steel and...
17.9K