Related Experiment Video
Updated: Aug 18, 2026

Monitoring ER/SR Calcium Release with the Targeted Ca2+ Sensor CatchER+
Published on: May 19, 2017
Maximal calcium extrusion capacity and stoichiometry of the human red cell calcium pump
Abstract:
1. The uphill calcium efflux through calcium-saturated pumps in intact red cells was investigated with the aid of a new method, in initial conditions of uniform ionophore A23187-induced calcium distribution among the cells. The method is based on findings by Tiffert, García-Sancho & Lew (1984) which show that cobalt can suddenly arrest passive calcium transport by the ionophore and expose, without noticeable interference, uphill calcium extrusion by the pump. The results comprise methodological aspects and questions concerning interactions between inner pump sites, ATP and Ca2+, and the calcium: ATP stoichiometry of the calcium-saturated pump. 2. Ionophore-induced calcium influx was set to be far in excess of the maximal calcium pump capacity. This secured a uniform calcium distribution among the cells, and Ca2+ equilibration by 2 min or less of calcium permeabilization. Cobalt was added between 15 s and 5 min after ionophore addition. The calcium and ATP content of the cells was followed during ionophore-induced influx and cobalt-exposed efflux. 3. The external cobalt concentrations required to block completely ionophore-mediated calcium transport were similar or only marginally higher than those of calcium. 4. The reproducibility of independent cobalt-exposed calcium efflux measurements from single blood samples was within an 8% range. 5. During cobalt-exposed calcium efflux, the calcium content of subpopulations of cells, with and without active Ca2+-sensitive K+ channels, investigated by post-incubation of samples in low-K+, thiocyanate (SCN-) media (modified from García-Sancho & Lew, 1988a), was similar. This is consistent with the maintenance of a uniform calcium distribution among the cells during uphill calcium extrusion. 6. Cobalt-exposed calcium efflux was similar in the interval from 15 s to 5 min after calcium permeabilization although cell ATP levels had fallen by over 50% in that period. Therefore, cell ATP concentrations within the physiological range do not seem to be regulatory for calcium-saturated pumps in the intact red cell. 7. All cobalt-exposed calcium efflux curves were linear in time, at least until total cell calcium contents reached levels below 100 mumol/l cells. This suggests that internal calcium is not inhibitory for calcium-saturated efflux in intact cells in the 0.1-1 mmol/l cells range. 8. The cobalt-exposed calcium fluxes were in the range from 4 to 24 mmol/(1 cells.h) for fresh cells and from 10 to 18 mmol/1 cells. h) for samples from the Blood Bank.(ABSTRACT TRUNCATED AT 400 WORDS)
More Related Videos
Related Concept Videos
Primary Active Transport
Primary Active Transport
ATP Driven Pumps II: P-type Pumps
A typical P-type pump has three cytosolic domains: nucleotide-binding (N), phosphorylation (P), and activator (A) domains. These domains are connected to the membrane-spanning helices by short amino acid segments. ATP hydrolysis and covalent phosphoenzyme intermediate formation are crucial parts of the catalytic cycle. At the highly...
ATP Driven Pumps III: V-type Pumps
The peripheral or cytosolic V1 domain with eight subunits is involved in ATP hydrolysis. The integral or transmembrane V0 domain containing at least five subunits...
Feedback Regulation of Calcium Concentration
Various transmembrane receptors, such as G protein-coupled receptors (GPCRs), elicit a response to extracellular signals by increasing cytosolic calcium. Activated GPCRs...
Skeleton and Calcium Homeostasis

