Molecular characterization of polyethylene oxide based oligomers by surface-assisted laser desorption/ionization mass...

Molecular characterization of industrial oligomeric products is performed using surface-assisted laser desorption/ionization mass spectrometry (SALDI-MS), termed desorption ionization using a through-hole alumina membrane (DIUTHAME). This paper describes the unique feature of a DIUTHAME chip applying active SALDI, which generates specific types of fragments of polyglycol samples.

Polyethylene oxide (PEO) and PEO-based materials were subjected to SALDI-MS. The influence of the presence or absence of a cationization salt on the mass spectrum was investigated. The resulting mass spectra composed of fragment ions were compared with those obtained by collision-induced dissociation (CID)-MS/MS. The specific fragment ions generated using the DIUTHAME chip were further subjected to high-energy CID-MS/MS.

The addition of a cationization salt resulted in SALDI mass spectra with fewer fragment peaks. The mass spectra obtained without adding the cationization salt were composed of many more fragment ions caused by in-source decay. The fragmentation pattern was similar to that seen with low-energy CID. The resulting fragment ions were formed by selective cleavage at the C-O bond. High-energy CID-MS/MS can be performed for the specific fragment ions generated by in-source decay fragmentation.

Molecular characterization of PEO-based oligomers by SALDI-MS using the DIUTHAME chip was successfully demonstrated. The selective fragmentation and high-energy CID-MS/MS of the in-source decay fragments made it possible to provide more detailed structural information. This unique feature of DIUTHAME gives it potential for use in new molecular characterization techniques.