Polar and phase domain walls with conducting interfacial states in a Weyl semimetal MoTe2

Fei-Ting Huang1, Seong Joon Lim1, Sobhit Singh2

  • 1Rutgers Center for Emergent Materials and Department of Physics and Astronomy, Rutgers University, Piscataway, NJ, 08854, USA.

Nature Communications
|September 19, 2019
PubMed

Related Concept Videos

The Frequency Domain Thermoreflectance Technique for Thermal Property Measurements09:10

The Frequency Domain Thermoreflectance Technique for Thermal Property Measurements

This article presents the Frequency Domain Thermoreflectance (FDTR) technique for local nondestructive thermal characterization and...
577
Time and frequency -Domain Interpretation of Phase-lead Control01:24

Time and frequency -Domain Interpretation of Phase-lead Control

Phase-lead controllers are commonly used in various control systems to enhance response speed and stability. Adjusting the brightness on a television screen offers a practical example of phase-lead control. When contrast is enhanced, a phase-lead controller is employed. Mathematically, phase-lead control is identified when the first parameter is smaller than the second.
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...
433
Time and frequency -Domain Interpretation of Phase-lag Control01:21

Time and frequency -Domain Interpretation of Phase-lag Control

Phase-lag controllers are widely used in control systems to improve stability and reduce steady-state errors. A dimmer switch controlling the brightness of a light bulb serves as a practical example of phase-lag control, gradually adjusting the bulb's brightness. Mathematically, phase-lag control or low-pass filtering is represented when the factor 'a' is less than 1.
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...
396
Thin Layer Chromatography-Based Separation of Mycolic Acid Variants: A Method to Separate Mycobacterial Cell Wall Lipids Based on Polarity03:26

Thin Layer Chromatography-Based Separation of Mycolic Acid Variants: A Method to Separate Mycobacterial Cell Wall Lipids Based on Polarity

This video demonstrates the thin-layer chromatography-based separation of mycolic acids. This technique separates the different mycolic acids—long-chain lipids present in the cell wall of mycobacteria—based on their...
1.6K
Group Polarization01:01

Group Polarization

Group polarization is the strengthening of an original group attitude following the discussion of views within a group (Teger & Pruitt, 1967). That is, if a group initially favors a viewpoint, after discussion the group consensus is likely a stronger endorsement of the viewpoint. Conversely, if the group was initially opposed to a viewpoint, group discussion would likely lead to stronger opposition.
38.4K
Concurrent Quantitative Conductivity and Mechanical Properties Measurements of Organic Photovoltaic Materials using AFM08:59

Concurrent Quantitative Conductivity and Mechanical Properties Measurements of Organic Photovoltaic Materials using AFM

Organic photovoltaic (OPV) materials are inherently inhomogeneous at the nanometer scale. Nanoscale inhomogeneity of OPV materials affects performance of photovoltaic devices. In this paper, we describe a protocol for quantitative measurements of electrical and mechanical properties of OPV materials with sub-100 nm...
12.1K