Related Experiment Video
Updated: Jan 19, 2026

Design and Analysis for Fall Detection System Simplification
Published on: April 6, 2020
Burden associated with nonfatal slip and fall injuries in the surface stone, sand, and gravel mining industry
Mahiyar F Nasarwanji1, Kan Sun1
1Pittsburgh Mining Research Division, National Institute for Occupational Safety and Health, 626 Cochrans Mill Road, Pittsburgh, PA 15236, USA.
Abstract:
Slips, trips, and falls (STFs) pose a significant financial burden to employers and account for over 33% of the total nonfatal workers' compensation cost in the United States. Previous analyses documenting the burden of STF incidents in the mining industry have focused on occupational fatalities or STFs during equipment ingress, egress. There is limited information on the burden of nonfatal STF incidents in the mining industry and most of it is outdated. Hence, to increase awareness and highlight the importance of STFs in the mining industry, this analysis documents the burden associated with nonfatal STF incidents at surface stone, sand, and gravel (SSG) mines from 2008 through 2017. In this time frame, nonfatal STF incidents occurred at a rate of 62 per 10,000 full-time equivalent (FTE) employees per year. Pits had a higher prevalence of injuries, but plants had a higher incidence rate. In addition, nonfatal STF incidents at surface SSG mines led to approximately 23,800 total days lost per year with an estimated cost to the mining industry of $17.5 million per year. Assessed violations that are not related to reported injuries but are related to STF hazards identified during Mine Safety and Health Administration (MSHA) inspections cost the mining industry approximately $3 million per year from 2013 through 2017. Based on the data analyzed in this study, falls to the lower level pose a higher burden in terms of cost; however, falls to the same level have a higher number of incidents and incidence rate.
More Related Videos
06:35Using Gold-standard Gait Analysis Methods to Assess Experience Effects on Lower-limb Mechanics During Moderate High-heeled Jogging and Running
Published on: September 14, 2017
09:46Training Persons with Spinal Cord Injury to Ambulate Using a Powered Exoskeleton
Published on: June 16, 2016
Related Concept Videos
Quarrying of Stone
One common method involves using a diamond belt saw to cut large blocks from the quarry face. These blocks can be about 50 feet long and 12 feet high. After the initial vertical cut, drilling is performed at the base of the...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Survey Safety
Bulk Density of Aggregate
Most natural mineral aggregates, like sand and gravel,...
Aggregates Classification
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
Free-body Diagrams: Problem Solving
For example, consider a block with a mass of 10 kg released on an inclined plane at an angle of 30° to the horizontal, where...