Related Experiment Video
Updated: Jan 6, 2026

Sandy Soil Improvement through Microbially Induced Calcite Precipitation MICP by Immersion
Published on: September 12, 2019
Unconfined Compressive Properties of Composite Sand Stabilized with Organic Polymers and Natural Fibers
Yuxia Bai1, Jin Liu2, Zezhuo Song3
1School of Earth Sciences and Engineering, Hohai University, Nanjing 210098, China. baiyuxia@hhu.edu.cn.
Abstract:
As renewable and environment-friendly materials, coir and sisal natural fibers can be used in soil reinforcement with minimum cost and other benefits. In this study, we focused on their improvements of unconfined compressive properties of polymer treated sand. In total, 36 groups of unconfined compressive strength tests, combined with X-ray diffraction and scanning electron microscope investigations were performed. We had studied the effects of polymer and fiber contents, and fiber types on the reinforcement effectiveness. The results showed that both coir and sisal fiber can improve the mechanical properties and microstructure of treated sand. In terms of strength properties, sisal fiber inclusion was better than coir fiber, while both have a similar reinforcement benefit on soil ductile behaviors. The strength and compressive energy increased with an increment in polymer and fiber content. The reinforced sand can have up to 1 MPa compressive strength and 140 kPa compressive energy for coir fiber inclusion, while 1.2 MPa and 170 kPa, respectively, for sisal fiber. The axial stress-strain characteristics and failure patterns were also improved, and the brittle index decreased toward zero, which suggests an increasing ductile. The polymer membrane enwrapping and bonding sand grains, and the network structure built by fiber crossing and overlapping among sand grains, as well as the interfacial attachment conferred by polymer between sand grains and fiber, all contributed to the reinforcement of treated sand.
More Related Videos
09:54Author Spotlight: Enhancing Fiber Composite Laminate Quality with the Wet Hand Lay-Up/Vacuum Bag Process
Published on: June 30, 2023
05:38Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Related Concept Videos
Fiber Reinforced Concrete
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Behavior of Concrete Under Compressive Load
As the concrete specimen fractures under...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Additives and Fillers in Concrete
The...