Related Experiment Video
Updated: Jan 6, 2026

Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
Insertion loss of asymmetrical balconies on a building façade
1Department of Building Services Engineering, The Hong Kong Polytechnic University, Hong Kong, China.
Abstract:
The acoustical insertion loss of asymmetrical balconies on high-rise buildings was studied experimentally using a 1:3 scaled down model in the present study. Four balcony forms featured by the presence of a full-height side-wall were included. A linear loudspeaker array was adopted as the sound source. The effects of source orientation and balcony elevation angle on the insertion loss and its spectral variation were examined. The position of the full-height side-wall relative to the sound source significantly affects the balcony insertion loss. It is observed that the maximum traffic noise amplification and attenuation are both ∼6 dBA. Results also suggest that the balustrade has no effect on the insertion loss spectral variation pattern, though the insertion loss magnitude could be much reduced without it in the presence of a short side-wall. This short side-wall determines the insertion loss spectral variation pattern. Significant sound amplification is found at frequencies of the odd order transverse modes, the longitudinal modes, and their coupled modes regardless of balcony form and elevation angle. It is also found that the major acoustic mode interactions are basically independent of source orientation for balconies without the short side-wall.
Related Concept Videos
Masonry Curtain Walls
Composite Masonry Walls
Posttensioned Masonry Walls
Post-tensioned masonry walls use high-strength steel rods or flexible tendons to enhance the strength and efficiency of masonry structures. These elements are securely anchored to the foundation and extend vertically either within the cores of the masonry units or between the masonry wythes. The construction process involves building the wall with these tensioning elements in place and allowing the mortar to fully cure.
Following the curing process, the tensioning begins. Steel rods are...
Spanning Openings in Brick Walls
Lintels are primary supports used to span openings and can be crafted from materials such as reinforced concrete, steel-reinforced brick masonry, or simple steel angles. These are straightforward to install and are typically concealed...
Types of Building Separation Joints
Volume-change joints address the effects of expansion and contraction due to temperature and moisture variations. They are strategically placed at discontinuities in a building's mass where cracking is most likely and are spaced about 150 to 200...
Reinforced Brick Masonry
To fortify brick walls...

