Related Experiment Video
Updated: Jan 6, 2026

The Measurement of Unsteady Surface Pressure Using a Remote Microphone Probe
Published on: December 3, 2016
Measurement and characterization of infrasound from a tornado producing storm
Brian R Elbing1, Christopher E Petrin1, Matthew S Van Den Broeke2
1Mechanical & Aerospace Engineering, Oklahoma State University, Stillwater, Oklahoma 74078, USA.
Abstract:
A hail-producing supercell on 11 May 2017 produced a small tornado near Perkins, Oklahoma (35.97, -97.04) at 2013 UTC. Two infrasound microphones with a 59-m separation and a regional Doppler radar station were located 18.7 and 70 km from the tornado, respectively. Elevated infrasound levels were observed starting 7 min before the verified tornado. Infrasound data below ∼5 Hz was contaminated with wind noise, but in the 5-50 Hz band the infrasound was independent of wind speed with a bearing angle that was consistent with the movement of the storm core that produced the tornado. During the tornado, a 75 dB peak formed at ∼8.3 Hz, which was 18 dB above pre-tornado levels. This fundamental frequency had overtones (18, 29, 36, and 44 Hz) that were linearly related to mode number. Analysis of a larger period of time associated with two infrasound bursts (the tornado occurred during the first event) shows that the spectral peaks from the tornado were present from 4 min before to 40 min after tornadogenesis. This suggests that the same geophysical process(es) was active during this entire window.
More Related Videos
Related Concept Videos
Measurement of Fluid Pressure
A basic form of manometer is the piezometer, a vertical tube open at the top and filled with the same...
Intensity and Pressure of Sound Waves
Unlike the time average of a sinusoidal term, which is zero since it is positive...
Sound Intensity Level
The human ear can perceive an extensive range of sound intensity, necessitating the use of the logarithmic scale to define a physical quantity—the intensity level. It is a ratio of two intensities and...
Shock Waves
When the source's speed approaches the speed of sound, constructive interference between successive wavefronts emitted by the source occurs immediately behind it. Initially, scientists believed that this constructive interference would result in such high...
Measurement of Air Content in Concrete
The pressure method,...
Deriving the Speed of Sound in a Liquid
The speed of sound in fluids can be derived by considering a mechanical wave...

