Validation of an analytical method using HS-SPME-GC/MS-SIM to assess the exposure risk to carbonyl compounds and...

Compounds with toxic potential may occur in beer, such as carbonyl compounds (acetaldehyde, acrolein, ethyl carbamate [EC] and formaldehyde) and furan derivatives [furfural and furfuryl alcohol (FA)]. The objective of this study was, for the first time, to validate a method based on headspace-solid phase microextraction using a PDMS-overcoated fibre and gas chromatography with mass spectrometric detection in selected ion monitoring mode (HS-SPME-GC/MS-SIM) to investigate target carbonyl compounds and furan derivatives in beers. Analytical curves showed proper linearity with r² ranging from 0.9731 to 0.9960 for acetaldehyde and EC, respectively. The lowest LOD was found for acetaldehyde (0.03 µg L^-1), while the lowest LOQ value (1.0 µg L^-1) was found for acetaldehyde and EC, formaldehyde and furfural. Recovery (90% to 105%), intermediate precision and repeatability (lower than 13%), limits of detection and quantification (values below 2.5 μg L^-1) showed that the method is suitable to simultaneously quantify these compounds. EC was detected in only two samples (1 lager and 1 ale). Furfural was found in 37% and 82% of ale and lager beers, respectively. Acetaldehyde, acrolein, formaldehyde and FA were detected in all samples. However, acrolein was the only compound found in the commercial samples at a concentration capable of causing health risk. Besides furfural and FA, four other furan-containing compounds (5-methyl-2-furan methanethiol, acetylfuran, 5-methylfurfural and γ-nonalactone) were also found in beers, however, at levels low enough not to impose potential health risk.