Weber's Law and the Scalar Property of Timing: A Test of Canine Timing

Jessica H Cliff1, Surrey M K Jackson2, James S McEwan3

  • 1School of Psychology, The University of Waikato/Te Whare Whãnanga o Waikato, Hamilton 3240, New Zealand. jesskelmere@hotmail.co.nz.

Related Concept Videos

Dimensional Analysis03:40

Dimensional Analysis

Dimensional analysis, also known as the factor label method, is a versatile approach for mathematical operations. The main principle behind this approach is: the units of quantities must be subjected to the same mathematical operations as their associated numbers. This method can be applied to computations ranging from simple unit conversions to more complex and multi-step calculations involving several different quantities and their units.
Conversion Factors and Dimensional Analysis
The unit...
58.5K
Timing and Consequences on Behavior01:08

Timing and Consequences on Behavior

In operant conditioning, the timing of reinforcement is crucial. For animals like rats and cats, immediate reinforcement (within a few seconds) is much more effective than delayed reinforcement. For example, a food reward for a rat needs to follow within 30 seconds of pressing a bar to be effective. 
Humans, however, can respond to delayed reinforcers. We often make decisions between immediate small rewards and delayed larger rewards. This ability to delay gratification is a significant...
321
Lenz's Law01:15

Lenz's Law

The direction in which the induced emf drives the current around a wire loop can be found through the negative sign. However, it is usually easier to determine this direction with Lenz's law, named in honor of its discoverer, Heinrich Lenz (1804–1865). Lenz's law states that the direction of the induced emf drives the current around a wire loop always to oppose the change in magnetic flux that causes the emf.
If a bar magnet is moved toward a coil such that the magnetic flux...
5.9K
Introduction to Scalars01:21

Introduction to Scalars

Many familiar physical quantities can be specified completely by giving a single number and the appropriate unit. For example, "a class period lasts 50 min," or "the gas tank in my car holds 65 L," or "the distance between the two posts is 100 m." A physical quantity that can be specified completely in this manner is called a scalar quantity. The word "scalar" is a synonym for "number." Time, mass, distance, length, volume,...
19.6K
Time-Domain Interpretation of PD Control01:07

Time-Domain Interpretation of PD Control

Proportional-Derivative (PD) control is a widely used control method in various engineering systems to enhance stability and performance. In a system with only proportional control, common issues include high maximum overshoot and oscillation, observed in both the error signal and its rate of change. This behavior can be divided into three distinct phases: initial overshoot, subsequent undershoot, and gradual stabilization.
Consider the example of control of motor torque. Initially, a positive...
343
Time and frequency -Domain Interpretation of Phase-lag Control01:21

Time and frequency -Domain Interpretation of Phase-lag Control

Phase-lag controllers are widely used in control systems to improve stability and reduce steady-state errors. A dimmer switch controlling the brightness of a light bulb serves as a practical example of phase-lag control, gradually adjusting the bulb's brightness. Mathematically, phase-lag control or low-pass filtering is represented when the factor 'a' is less than 1.
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...
372