Monopodal Postural Stability Assessment by Wireless Inertial Measurement Units Through the Fast Fourier Transform

(1) To describe the fast Fourier transform (FFT) multijoint as monopodal postural stability measurement in well-trained athletes, (2) to compare the within-subject FFT between laterality, joints, and body segments, and (3) to establish the within- and between-subject relationship between joints.

Twelve national-level basketball players participated voluntarily in this investigation. The participants performed two 60-second repetitions of a monopodal stability test (1 repetition with each lower limb), separated by 3 minutes of active recovery. All tests were recorded by 4 WIMU PRO™ inertial devices located on the ankle, knee, lumbar spine, and thoracic spine. The main variable was total acceleration, where the FFT was applied.

The higher instability results were found in the ankle and in the nondominant lower limb (dominant = 1.131 [0.122] a.u. (arbitrary units); nondominant = 1.141 [0.172] a.u). In the body segment analysis, the greater percentage of differences (%diff) were shown between lumbar spine and knee in the dominant (%diff = -2.989%; d = 0.87) and nondominant (%diff = -3.243%; d = 0.90) lower limb. Finally, very large between-subjects variability was found in all joints and body segments.

The described protocol is proposed for monopodal postural stability assessment, being useful to provide information about the stability of joints and the body segment between joints. Besides, a within-subject analysis is recommended, and the FFT calculation will enable a linear analysis of each test.