Aquifer Storage and Recovery Using Saline Aquifers: Hydrogeological Controls and Opportunities

Aquifer storage and recovery (ASR) is a valuable tool for managing variations in the supply and demand of freshwater, but system performance is highly dependent upon system-specific hydrogeological conditions including the salinity of the storage-zone native groundwater. ASR systems using storage zones containing saline (>10,000 mg/L of total dissolved solids) groundwater tend to have relatively low recovery efficiencies (REs). However, the drawbacks of low REs may be offset by lesser treatment requirements and may be of secondary importance where the stored water (e.g., excess reclaimed, surface, and storm waters) would otherwise go to waste and pose disposal costs. Density-dependent, solute-transport modeling results demonstrate that the RE of ASR systems using a saline storage zone is most strongly controlled by parameters controlling free convection (e.g., horizontal hydraulic conductivity) and mixing of recharged and native groundwater (e.g., dispersivity and aquifer heterogeneity). Preferred storage zone conditions are moderate hydraulic conductivities (5 to 20 m/d), low degrees of aquifer heterogeneity, and primary porosity-dominated siliclastic and limestones lithologies with effective porosities greater than 5%. Where hydrogeological conditions are less favorable, operational options are available to improve RE, such as preferential recovery from the top of the storage zone. Injection of large volumes of excess water currently not needed into saline aquifers could create valuable water resources that could be tapped in the future during times of greater need.