Optimal conditions for olive mill wastewater treatment using ultrasound and advanced oxidation processes

The treatment of olive mill wastewater (OMW) in Jordan was investigated in this work using ultrasound oxidation (sonolysis) combined with other advanced oxidation processes such as ultraviolet radiation, hydrogen peroxide (H₂O₂) and titanium oxide (TiO₂) catalyst. The efficiency of the combined oxidation process was evaluated based on the changes in the chemical oxygen demand (COD). The results showed that 59% COD removal was achieved within 90 min in the ultrasound /UV/TiO₂ system. A more significant synergistic effect was observed on the COD removal efficiency when a combination of US/UV/TiO₂ (sonophotocatalytic) processes was used at low ultrasound frequency. The results were then compared with the COD values obtained when each of these processes was used individually. The effects of different operating conditions such as, ultrasound power, initial COD concentration, the concentration of TiO₂, frequency of ultrasound, and temperature on the OMW oxidation efficiency were studied and evaluated. The effect of adding a radical scavenger (sodium carbonate) on the OMW oxidation efficiency was investigated. The results showed that the sonophotocatalytic oxidation of OMW was affected by the initial COD, acoustic power, temperature and TiO₂ concentration. The sonophotocatalytic oxidation of OMW increased with increasing the ultrasound power, temperature and H₂O₂ concentration. Sonolysis at frequency of 40 kHz combined with photocatalysis was not observed to have a significant effect on the OMW oxidation compared to sonication at frequency of 20 kHz. It was also found that the OMW oxidation was suppressed by the presence of the radical scavenger. The COD removal efficiency increased slightly with the increase of TiO₂ concentration up to certain point due to the formation of oxidizing species. At ultrasound frequency of 20 kHz, considerable COD reduction of OMW was reported, indicating the effectiveness of the combined US/UV/TiO₂ process for the OMW treatment.