Related Experiment Video

Updated: Jan 4, 2026

Applying Permanent, Robust Stenciled Patterns of Fine Particles to Elastomeric Surfaces
07:12

Applying Permanent, Robust Stenciled Patterns of Fine Particles to Elastomeric Surfaces

Published on: July 8, 2025

399

Field-induced surface deformation of magnetoactive elastomers with anisometric fillers: a single-particle model

T A Nadzharyan1, O V Stolbov2, Yu L Raikher2

  • 1Faculty of Physics, Lomonosov Moscow State University, Moscow, 119991, Russia. kram@polly.phys.msu.ru and A. N. Nesmeyanov Institute of Organoelement Compounds of Russian Academy of Sciences, Moscow, 119991, Russia.

Soft Matter
|November 12, 2019
PubMed

More Related Videos

Laser Micromachining for Polymer Surface Topography Design05:49

Laser Micromachining for Polymer Surface Topography Design

Published on: September 19, 2025

386
Analyzing Cell Surface Adhesion Remodeling in Response to Mechanical Tension Using Magnetic Beads07:55

Analyzing Cell Surface Adhesion Remodeling in Response to Mechanical Tension Using Magnetic Beads

Published on: March 8, 2017

8.8K

Related Concept Videos

Members Made of Elastoplastic Material01:19

Members Made of Elastoplastic Material

The behavior of elastoplastic materials under bending stresses, particularly in structural members with rectangular cross-sections, is crucial for predicting material responses and understanding failure modes. Initially, when a bending moment is applied, the stress distribution across the section follows Hooke's Law and is linear and elastic. This distribution means the stress increases from the neutral axis to the maximum at the outer fibers, up to the elastic limit.
As the bending moment...
334
Residual Stresses in Bending01:18

Residual Stresses in Bending

In the study of elastoplastic members subjected to bending moments, understanding the loading and unloading phases is crucial for assessing material behavior and structural integrity. During the loading phase, as the bending moment increases, the material initially responds elastically, adhering to Hooke's Law, where stress is directly proportional to strain. When the load exceeds the yield strength, plastic deformation occurs, resulting in permanent strain and deformation that remains even...
478
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity01:15

Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity

Deformation occurs in axial and transverse directions when an axial load is applied to a slender bar. This deformation impacts the cubic element within the bar, transforming it into either a rectangular parallelepiped or a rhombus, contingent on its orientation. This transformation process induces shearing strain. Axial loading elicits both shearing and normal strains. Applying an axial load instigates equal normal and shearing stresses on elements oriented at a 45° angle to the load axis.
502
Elastic Strain Energy for Shearing Stresses01:20

Elastic Strain Energy for Shearing Stresses

As discussed in previous lessons, strain energy in a material is the energy stored when it is elastically deformed, a concept crucial in materials science and mechanical engineering. This energy results from the internal work done against the cohesive forces within the material. When a material undergoes shearing stress and corresponding shearing strain, the strain energy density, which is the energy stored per unit volume, is calculated. Within the elastic limit, where the stress is...
454