Related Experiment Video
Updated: Jan 3, 2026
Multimodal 3D Printing of Phantoms to Simulate Biological Tissue
Published on: January 11, 2020
Three-body wear of 3D printed temporary materials
Andreas Kessler1, Marcel Reymus1, Reinhard Hickel1
1Department of Conservative Dentistry and Periodontology, University Hospital, LMU Munich, Munich, Germany.
Objective:
The aim of this study was to investigate the three-body wear of different additively manufactured temporary materials, one temporary PMMA material for CAD/CAM milling and one resin-based composite for direct restorations as a control group by using an ACTA machine.
Methods:
Specimens (n=8) of the 3D printing materials 3Delta temp, NextDent C&B, Freeprint temp were additively manufactured by DLP 3D printer. Postprocessing was carried out according to the manufacturer's specifications. Telio CAD were cut out of blocks, Tetric EvoCeram was applied directly and light cured. Three-body wear was simulated with an ACTA machine. Data were statistically analysed (ANOVA, post hoc test: Tukey, p<0.05). The worn surfaces of the specimens were examined with a FE-SEM.
Results:
The average mean wear was 50±15μm for Tetric EvoCeram<62±4μm for 3Delta temp<236±31μm for Telio CAD<255±13μm for NextDent C&B<257±24μm for Freeprint temp. After 200,000 cycles, the wear and wear rates for Tetric EvoCeram and 3Delta temp were significantly lower than those for the other materials. SEM revealed that 3Delta temp has a higher filler proportion than the other 3D printing materials but less than Tetric EvoCeram.
Significance:
The filler content influences the wear behaviour of additively manufactured materials as well as dental restorative composite materials. While most 3D printing materials have a low inorganic filler load, which qualifies the materials for temporary use only, one 3D printing material has an optimized composition that would qualify the material for longer clinical service time if wear is considered as the outcome variable.
