Influence of Spectroscopic Techniques on the Estimation of the Degree of Conversion of Bulk-fill Composites

To compare the degree of conversion (DC) of different flowable and sculptable bulk-fill composites (BFC), at 0- and 4-mm depths from the surface, by Fourier transform infrared (FTIR), attenuated total reflection FTIR (ATR-FTIR), and FT-Raman spectroscopic techniques.

Six BFC were investigated, including three sculptable composites (Admira Fusion [Voco], Aura Bulk Fill [SDI], and X-tra Fill [Voco]) and three flowable composites (Venus Bulk Fill [Heraeus], Filtek [3M], and X-tra Base [Voco]). Three molds of each composite were light cured as specified by the manufacturer. For each mold, slices corresponding to 0-mm (surface) and 4-mm depth were analyzed by spectroscopic techniques: ATR-FTIR, FTIR, and FT-Raman. The spectra of uncured composite material were used as an analytical control for background subtraction of the treated composite. The area and amplitude of the reference peaks (1607 and 1637 cm^-1) were obtained to calculate the DC percentage at 0- and 4-mm depth. A Kruskal-Wallis nonparametric test was used for materials, and paired comparisons were made using Mann-Whitney nonparametric test. Wilcoxon's rank test was used for comparison between spectroscopic methods and between 0- and 4-mm depth in each composite. Significance was accepted at p<0.05.

FTIR showed significantly lower DC values, both in areas and amplitudes of the peaks, when compared with the results reported by different BFC. Differences between the surface and 4-mm depth were detected more precisely by FT-Raman. ATR-FTIR obtained DC values significantly higher than those obtained by FTIR.

The vibrational spectroscopy method significantly influenced DC measurements of the flowable and sculptable BFC explored.