Related Experiment Video
Updated: Jan 3, 2026

An Inertial Measurement Unit Based Method to Estimate Hip and Knee Joint Kinematics in Team Sport Athletes on the Field
Published on: May 26, 2020
Methods to collect and interpret external training load using microtechnology incorporating GPS in professional
Vincenzo Rago1,2, João Brito2, Pedro Figueiredo2,3
1Centre of Research, Education, Innovation and Intervention in Sport, Faculty of Sports, University of Porto , Porto, Portugal.
Abstract:
The aim of this article was to systematically review the methods adopted to collect and interpret external training load (ETL) using microtechnology incorporating global positioning system (GPS). The main deficiencies identified concerned the non-collection of match ETL, and the non-consideration of potential confounders (e.g. playing position, fitness level, starting status or session content). Also, complementary training (individual/reconditioning) and pre-match warm-up were rarely quantified. To provide a full picture of the training demands, ETL was commonly complemented by internal training load monitoring with the rating of perceived exertion predominantly adopted instead of heart rate recordings. Continuous data collection and interpretation of ETL data in professional football vary widely between observational studies, possibly reflecting the actual procedures adopted in practical settings. Evidence about continuous ETL monitoring in female players, and female as well as male goalkeepers is lacking.
More Related Videos
10:52Simulation of Human-induced Vibrations Based on the Characterized In-field Pedestrian Behavior
Published on: April 13, 2016
06:35Using Gold-standard Gait Analysis Methods to Assess Experience Effects on Lower-limb Mechanics During Moderate High-heeled Jogging and Running
Published on: September 14, 2017