Related Experiment Video
Updated: Jan 3, 2026

In Vitro Evaluation of The Effects Of Er,Cr:YSGG and Diode Lasers Used on Titanium Cylinder
Published on: June 6, 2025
Er:YAG Laser Irradiation Reduces Microbial Viability When Used in Combination with Irrigation with Sodium
Janina Golob Deeb1, John Smith1, B Ross Belvin2
1School of Dentistry, Virginia Commonwealth University, Richmond, VA 23298, USA.
Abstract:
The erbium-doped yttrium aluminum garnet (Er:YAG) laser is used to treat periodontal disease; however, its effectiveness at killing oral bacteria is not well known. Furthermore, the compounding effect of the combination of a laser treatment and irrigation methods with antimicrobials on bacterial viability is yet to be determined. The purpose of this in vitro study was to evaluate the effect of the Er:YAG laser with irrigation using chlorhexidine (CHX), hydrogen peroxide (H2O2), or sodium hypochlorite (NaOCl) on the viability of oral bacteria. Three bacterial species were used in our study: Streptococcus gordonii, Fusobacterium nucleatum, and Porphyromonas gingivalis. Bacteria were grown in an anaerobic chamber in brain heart infusion broth and incubated at 37 °C. Bacterial samples with an OD of 0.5 were irradiated with the Er:YAG laser at 2940 nm using a 400-µm Varian tip. The experiment was repeated four times using these parameters: 40 mJ, 40 Hz, and 1.6 W for 20 seconds with the 300 µs short pulse duration in contact mode. Treatment groups consisted of the following: (1) no treatment, (2) 0.5% H2O2 alone, (3) 0.5% NaOCl alone, (4) 0.03% CHX alone, (5) Er:YAG irradiation alone, (6) Er:YAG irradiation with 0.5% H2O2, (7) Er:YAG irradiation with 0.5% NaOCl, and (8) Er:YAG irradiation with 0.03% CHX. Microbial viability was determined through plating and colony counts and calculated into CFU/ml. Statistical analysis was done using a two-tailed paired t-test. The use of the Er:YAG laser alone failed to show statistically significant antibacterial activity against any of bacteria. The most effective mono-treatment with irrigation solutions for all three bacteria were 0.5% H2O2 and 0.5% NaOCl (p < 0.001 for each solution). Irrigation with 0.03% CHX was most effective against F. nucleatum (p < 0.01) and less against P. gingivalis and S. gordonii and showed the least antibacterial action alone but improved significantly in combination therapy (p < 0.05). The combined treatment with the Er:YAG showed the greatest and most significant improvement in the reduction of bacterial viability compared to any other treatment group (p < 0.05 for each combined treatment). Irradiation with the Er:YAG laser with the addition of 0.5% H2O2, 0.5% NaOCl, or 0.03% CHX under a short working time (20 s) resulted in a significant reduction of bacterial viability for all three bacterial species compared with any single treatment option. The combination of irradiation with the Er:YAG laser with the addition of 0.5% H2O2, 0.5% NaOCl, or 0.03% CHX resulted in a larger reduction of bacterial survival when compared to monotherapies with antimicrobial solutions or laser. The combination of the Er:YAG laser with a low concentration irrigant solution of 0.5% H2O2, 0.5% NaOCl, or 0.03% CHX could be an effective treatment protocol for the reduction of periodontal pathogens and thus suitable treatment for non-surgical periodontal therapy.
More Related Videos
06:06Adjunctive Diode Laser Therapy and Probiotic Lactobacillus Therapy in the Treatment of Periodontitis and Peri-Implant Disease
Published on: May 9, 2022
06:36Effects of Mechanical Methods Used in Peri-implantitis Treatment on Implant Surface Decontamination and Roughness
Published on: March 14, 2025
Related Concept Videos
Hand hygiene
Hand washing...
Chemical Agents for Microbial Control
Physical Methods for Controlling Microbial Growth: Radiation and Filtration
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...
Cleaning, Sterilization, and Disinfection
Cleaning
The cleaning process usually involves using water with detergents or enzymatic cleaner and removing foreign material from objects and surfaces, including organic material such as body fluids or inorganic material like soil. Cleaning is performed before high-level disinfection and sterilization because foreign materials on the cover of the devices interfere with process...